User's Manual

ManualsBrandsAnsen Electronics ManualsElectronicsRain Gauge Transmitter

7” TFT WIRELESS PROFESSIONAL WEATHER STATION & PHOTO ALBUM Owner’s Manual

Thank you for purchasing the new generation of 7” TFT weather station & photo album. Designed and engineered with the

state-of-art technology and components, this instrument will provide accurate and reliable measurement of weather forecast,

wind speed/direction, rainfall and indoor/outdoor temperature/humidity as well as a digital photo album. Read this manual

carefully to fully explore the features and functions of the new product.

The package includes

- Photo Frame (Main unit)

- Infrared (IR) remote control

- Wind meter (built-in thermo-hygrometer)

- Rain gauge

- Adapter

Additional tools needed for installation

- Small Phillips screwdriver

- Hexagonal Key

- Electric drill

- Pencil

- Level

- Mast, 1 – 1.25 inch (2.54 – 3.18 cm) in diameter (to mount the anemometer)

Buttons on the photo frame Press Functions

POWER Turn on or off the unit

UP/DOWN Move up or down in the setup mode

LEFT/RIGHT Select photos or move left or right in the SETUP mode

Enter Enter the display mode or confirm setting in setup mode

Exit Exit the current display mode

(When display is off, press any buttons except [POWER] to turn on the weather display mode for around 1 minute)

Buttons on the IR remote control Press Functions

POWER Turn on or off the unit

PHOTOS Enter photo mode

WEATHER Enter weather mode

WEATHER + PHOTOS Enter weather & photo mode

CALENDAR Enter calendar mode

SETUP Enter setup mode

SLIDESHOW Enable or disable slideshow function (only available in photo mode)

MENU Enter menu mode

ENTER Enter the display mode or confirm setting in setup mode

Exit Exit the current display mode

UP/DOWN Move up or down in the setup mode

LEFT/RIGHT Select photos or move left or right in the display mode

ZOOM Zoom in the photo

ROTATE Rotate the photo

(When display is off, Press any buttons except [POWER] on the remote control to turn on display for around 1 minute)

Summary of content (9 pages)

PAGE 1
7” TFT WIRELESS PROFESSIONAL WEATHER STATION & PHOTO ALBUM Owner’s Manual Thank you for purchasing the new generation of 7” TFT weather station & photo album. Designed and engineered with the state-of-art technology and components, this instrument will provide accurate and reliable measurement of weather forecast, wind speed/direction, rainfall and indoor/outdoor temperature/humidity as well as a digital photo album.
PAGE 2
INTITIAL SETUP BATTERY & ADAPTER INSTALLATION Photo Frame: Main Power Source: Plug in the 5.0V adapter into the adapter socket on the right for basic operation IR Remote Control Battery (CR2025) is included in the IR remote control. For initial setup, pull out the battery insulation sheet from the bottom of the IR remote control. To replace the battery, follow the instruction on the back of the IR remote control to pull out the battery door. Follow the battery polarity and replace a new CR2025 battery.
PAGE 3
4. Calibrating the anemometer & installing batteries After mounting the anemometer, follow these steps to calibrate the wind direction so that the anemometer properly measures the wind direction and transmit to the monitor. Be sure battery has been removed from the anemometer before the calibration. Important: The same calibration is needed for the first set up and every battery replacement. 1.
PAGE 4
6. Battery Installation for the rain gauge 1. Press the tabs back as indicated below to unlock the rain gauge cover 2. Lift the rain gauge cover off its base. Then carefully remove the packing tape from the bucket assembly 3. Open battery cover and insert 2 pieces of AA batteries according to the polarity indicated. Close the battery cover 4. Replace & lock the rain gauge cover on the base 5. Go to “SETUP” mode, select “SEARCH NOW” in the “WIRELESS SENSOR RECEPTION” section and exit.
PAGE 5
SUNNY PARTLY CLOUDY CLOUDY RAINY STORMY NOTE: Different geographical location such as inland area or coastal region has different weather forecasting response. In case your weather forecast always show the wrong weather forecast over a long period of time and does not reflect the actual weather condition, it is necessary to adjust the weather forecast to the current weather condition with the above setting procedure. OPERATION There are 5 display modes in the menu selection.
PAGE 6
1) Weather forecast – includes sunny, partly cloudy, cloudy, rainy & stormy 2) Pressure bar chart – shows pressure level & trend of the past 6 hours 3) Barometric pressure - pressure reading (refer SETUP mode for pressure unit setting) 4) Pressure trend – rising, steady or falling 5) Daily, weekly or monthly rainfall in inch or mm 6) Total Rainfall in inch or mm 7) Wind chill in degree F or C 8) Average wind speed in m/s, knots, mph & km/h 9) 16 resolution of average wind direction 10) Gust wind speed in m/
PAGE 7
CALENDAR MODE Press [LEFT] / [RIGHT] to show the calendar of the previous or next month Press [UP] / [DOWN] to show the calendar of the previous or next year To set the calendar, enter SETUP mode for setting SETUP MODE Press [UP]/[DOWN] to move to your setting item. Press [LEFT]/[RIGHT] to select the setting and press [ENTER] to confirm the setting.
PAGE 8
Clear All Rainfall Record Now: Yes / No Default Setting: Yes / No S/W Version: Software version TROUBLE SHOOTING - In case of power outage, the unit will shut off completely and the synchronization of RF remote sensor will be lost. You are required to set up the remote sensor & weather forecast again following the procedures in the manual. - After every battery replacement of the remote sensor, you are required to follow the procedure in the manual to setup the remote sensor again.
PAGE 9
: 0 – 108 km/h : 0 – 67 mph : 0 – 58.3 knot Rain Gauge reading : 0 – 9999 mm : 0 – 393.66 inch Power : 5.0V adapter for photo frame : AA x 2 pcs for wind meter : AA x 2 pcs for rain gauge : CR2025 x 1 pc for IR remote control NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER AUTHORITY TO OPERATE THE EQUIPMENT This device complies with part 15 of the FCC Rules.