User's Manual

Table Of Contents

WIRELESS THERMOMETER SENSOR

Owner’s Manual

NAME AND FUNCTIONS OF BUTTONS:

Functions

Tx Press to transmit RF signal to the receiver

C/F Toggle degree C & F unit

Channel 1, 2, 3 Slide to select channel 1, 2 or 3

SETTING UP THE WIRELESS THERMOMETER SENSOR

 Loosen the screws on the battery door with a small screwdriver, insert 2 pieces of AAA batteries

according to the polarity indicated

 Set Channel 1 for the first wireless sensor. Set channel 2 and channel 3 for the 2

and 3

sensor

 Press [C/F] button to change the temperature unit displayed on the wireless sensor

 Follow the operation in the users’ manual of the main unit (receiver) to enter the RF searching

mode. (You may also reset the main unit by removing and reinstalling main unit’s batteries in

order to enter the RF searching mode)

 Press [TX] button to transmit RF signal to the main unit

 When RF connection is established, the respective temperature reading of the selected channel

will appear on the main unit

Note: Make sure the transmission is within range and path is clear of obstacles and RF interferences.

Shorten the distance between the main unit & wireless sensor if RF connection cannot be established.

Then follow the above procedure to setup the sensor again.

LOW BATTERY INDICATION

Low battery indication is available on the wireless sensor. Replace the batteries and follow the setup

procedure in this instruction manual.

BATTERY DISPOSAL

Replace only with the same or equivalent type recommended by the manufacturer.

Please disposal of old, defective batteries in an environmentally friendly manner in accordance with

the relevant legislation.

SPECIFICATIONS

Wireless sensor : -20 C to +60 C (-4 F to +140 F)

Channel : max. 3 channels

Transmission frequency: 434 MHz

Display Resolution: 0.1 degree

PAGE 1
WIRELESS THERMOMETER SENSOR Owner’s Manual NAME AND FUNCTIONS OF BUTTONS: Functions Tx Press to transmit RF signal to the receiver C/F Toggle degree C & F unit Channel 1, 2, 3 Slide to select channel 1, 2 or 3 SETTING UP THE WIRELESS THERMOMETER SENSOR Loosen the screws on the battery door with a small screwdriver, insert 2 pieces of AAA batteries according to the polarity indicated Set Channel 1 for the first wireless sensor.
PAGE 2
Power: AAA x 2 pcs This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received,including interference that may cause undesired operation. NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT.