User's Manual

ManualsBrandsAnsen Electronics ManualsElectronicsRemote Sensor

DIGITAL BAROMETER WITH RADIO-CONTROLLED WIRELESS THERMO-CLOCK

Owner’s Manual

Thank you for purchasing the new generation electronic weather station. Designed and

engineered with the state-of-art technology and components, this instrument will provide

accurate and reliable measurement of air pressure, humidity and in/ out temperatures.

Read this manual carefully to full explore the features and functions of the new product.

This Device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference, and (2)

the device must accept any interference received, including interference that may

cause undesired operation.

NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV

INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS

EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER AUTHORITY TO

OPERATE THE EQUIPMENT

Name and Functions of Buttons:

Press Functions

Hold 3 seconds

CHANNEL Select Channel 1,2,3, auto scroll Delete current channel

SET/ ZONE Select P/ M/ C/ E Zone Time

ALARM Read Alarm 1, Alarm 2 Alarm time setting

Read alarm time 5 sec at normal mode

MAX/ MIN Read maximum/ minimum temperatures, humidity & air pressure

(hold 3 sec to select C/ F)

(BARO)

Up Step advance for pressure Fast advance

Down Step backward for pressure Fast backward

BARO Confirm barometer setting

Summary of content (5 pages)

PAGE 1
DIGITAL BAROMETER WITH RADIO-CONTROLLED WIRELESS THERMO-CLOCK Owner’s Manual Thank you for purchasing the new generation electronic weather station. Designed and engineered with the state-of-art technology and components, this instrument will provide accurate and reliable measurement of air pressure, humidity and in/ out temperatures. Read this manual carefully to full explore the features and functions of the new product. This Device complies with Part 15 of the FCC Rules.
PAGE 2
+ 1 step forward (for clock) Fast advance Alarm 1, 2 on/off - 1 step backward (for clock) Fast backward RCC Sync SNOOZE Trigger snooze alarm & extended backlight BATTERY INSTALLATION Home Receiver: Lift off the battery cover at the back, install 2 pcs AA batteries according to the polarity indicated, close the battery cover. Remote Sensor: Lift off the bracket stand, loose the 4 screws with a small screwdriver, insert 2 pcs AAA batteries according to the polarity indicated.
PAGE 3
RADIO-CONTROLLED CLOCK The unit will start synchronizing the clock after the 1st channel of the RF thermometer is registered. At normal mode, hold “ – “ button 3 seconds for force synchronization. The antenna icon will appear during synchronization, if the icon disappear afterwards, radio time signal is not available at the moment. Try other locations later. Place the unit away from source of interference such as mobile phones, appliances, TV etc.
PAGE 4
Pressure Tendency: Rising Steady Falling CLOCK & CALENDAR SETTING Hold “SET/ ZONE “ button for 3 seconds to enter clock set. Using “ + , - “ to adjust and “ SET/ ZONE ” to confirm, the following values can be set in sequence: Year > Month > Date > Hr > Min > 12/ 24 > DST on/ off At normal mode, press SET/ ZONE to select the 4 Time Zones in USA: PST - Pacific Time MST - Mountain Time CST - Central Time EST - Eastern Time ALARM SETTING Hold “ALARM“ for 3 seconds.
PAGE 5
LOW BATTERY INDICATION Low battery indication is available for the home unit itself and all of the 3 remote channels. Replace the batteries and follow the setup procedure as mentioned in this instruction manual. BATERY DISPOSAL Replace only with the same or equivalent type recommended by the manufacturer. Please disposal of old, defective batteries in an environmentally friendly manner in accordance with the relevant legislation.