INSTRUCTION MANUAL 1
WELCOME ANSR: HALO™ is a beautifully simple answer for reducing the signs of aging. ANSR: HALO™ light therapy treatment uses the latest generation of LED technology and specific wavelengths of red and infrared light. These combined wavelengths of light reduce the appearance of fine lines, wrinkles, and discoloration, while helping to even out skin texture and tone. For best results use for five minutes, twice a day, for six to eight weeks for maximum benefit.
READ ALL INSTRUCTIONS CAREFULLY BEFORE USING DANGER To reduce the risk of electrical shock: IMPORTANT SAFEGUARDS When using ANSR: HALOTM basic safety precautions should always be followed. 3 • Always attach the AC/DC power adapter to the ANSR: HALO™ first, then into an electrical outlet. • Do not place or store ANSR: HALO™ where it can fall or be pulled into a tub or sink. • Do not place in or drop into water or other liquid.
WARNING To reduce the risk of potentially serious injury: • Do not aim the red light at your eyes or stare directly at the light source while it is in operation. You may momentarily glance at the light for a second or two. ANSR: HALO™ meets international lamp safety standards for light-emitting diodes. • Do not allow children to use the ANSR: HALO™ unsupervised. • Never attempt to open or repair the device or charger. There are no user-serviceable parts inside the ANSR: HALO™.
MAIN FEATURES & CONTROLS LENS surface projects red and infrared light and is applied directly to the area to be treated. POWER BUTTON allows you to turn the device on/ off, turn on the red and infrared light, and check the power level of the battery. BATTERY LEVEL INDICATOR shows three LED lights when fully-charged. Two lights = about 2/3 battery life. One light = 1/3 or less battery left. POWER JACK PORT is where you plug in the power adapter for charging.
GETTING STARTED • Unpack the ANSR: HALO, the instruction manual, and AC/DC power adapter. • Read all instructions before using your ANSR: HALO. • Prior to initial use, charge the device. Use only the AC/DC power adapter provided with the device. Plug the power adapter jack into the bottom of the device and connect to an electrical outlet. Charge ANSR: HALO fully, until all three white indicator lights are illuminated. This will take approximately two hours. Unplug the device once it is fully charged.
naked eye), the infrared lights will be operating. You will feel ANSR: HALO vibrate while the device is operating. USING THE LIGHT • Place the lens in direct contact with your skin and gently move back and forth in a slow, patterned motion over your entire face. Keep the light pressed gently to the skin without pulling or dragging. You may choose to focus on a specific area of concern for the full treatment cycle and then repeat over other areas as necessary. Each treatment cycle is 5 minutes in duration.
CHARGING THE LIGHT • Plug the AC/DC power adapter jack into the bottom of the ANSR: HALO and into an electrical outlet. Charge the device fully. Three white lights will illuminate to indicate the device is fully charged. This will take approximately two hours. Unplug the device once it is fully charged. • To recharge, plug the AC/DC power adapter into the ANSR: HALO and then into the electrical outlet. A single white LED illuminated denotes a charge of up to one-third.
TROUBLESHOOTING You should reset your ANSR: HALO if one of these things is happening: • The vibrator is operating without the red light operating • The device is not going into or coming out of a charge mode • The battery level indicator lights are behaving strangely TO RESET THE ANSR: HALO: Press and hold the power button down until the red light shuts off. This will take approximately 10 seconds. One white indicator light will come on briefly. This will cause the unit to re-enter IDLE mode.
CUSTOMER SERVICE In North America, call the ANSR: customer service team with any question or to customize your ANSR: skin care regimen. If you are outside North America, contact your local distributor. WARRANTY Register your ANSR: HALO at ANSR.com/warranty. Your ANSR: HALO is warranted to be free from defect in material and workmanship for a period of one year under normal use, after its original purchase date.
ANSR: SHALL NOT BE RESPONSIBLE FOR ANY INCIDENTAL, SPECIAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THIS PRODUCT. ALL IMPLIED WARRANTIES INCLUDING BUT NOT LIMITED TO IMPLIED WARRANTIES OF FITNESS AND MERCHANT ABILITY ARE LIMITED IN DURATION TO ONE YEAR FROM THE DATE OF ORIGINAL PURCHASE. This warranty gives you specific legal rights, and you may also have other rights that vary depending on your state, province or other jurisdiction.
AC/DC Power Adaptor Model Number Input Power Output Power Weight Case Size Operating Temperature Operating Humidity Storage Temperature EPS050100-P12-C1 110 to 120 VAC, 50 to 60 Hz 5 VDC at 1 Amp 76 Grams 63mmL x 26.
B E M O RE E N L I G H T E N ED A T A N SR .