User Manual

ENGLISH

ANTMIX Series | User manual

SERIES

User manual | ANTMIX Series

9 BAL

The BAL knob sets the left-right balance for stereo channels.

If only one signal is connected to the L/MONO socket, this

knob acts like a pan.

10 MUTE & LED - 12FX only

Press this button to mute the selected channel source.

The lit LED indicates the MUTE activation.

11 PFL & LED - 12FX only

Press this button to check channel signal level before the fader.

It works also if the channel is muted; the led indicates the

activation of the command.

12 PEAK

This LED is lit when the input signal is very loud and is close

to distortion.

When the LED is continuously lit, please lower the input gain

or adjust channel EQ, so reducing the boost introduced by

HI, MID, and LOW gains.

13 GR 1-2 - 12FX only

Press this button to send the channel signal to GROUP OUT

1-2 outputs.

14 L-R - 12FX only

Press this button to send the channel signal to MAIN MIX

L-R outputs.

15 VOLUME

Use this knob (6FX) or this fader (8FX & 12FX) to adjust

channel volume.

3 EQ

Use this two-band equalizer to boost or

to cut HI and LOW frequencies to get the

best mix in any environment.

1 LINE INPUT

Unbalanced line input with RCA L/R sockets.

2 LINE INPUT

Two 6.35 mm. (1/4”) balanced line input. You can also use an unbalanced

cable.

3.1.3 | STEREO INPUT

8 FX

12 FX