User Manual

ENGLISH
ANTMIX Series | User manual
16 17
SERIES
User manual | ANTMIX Series
1 POWER ON/OFF
Press this switch, located on mixer rear panel, to turn ON or OFF the unit.
2 AC ADAPTER IN
Connect only the power supply provided to this socket.
WARNING: to prevent unit accidental switch-off, x the cable to the rear panel hook.
3.1.5 | 8FX - POWER SUPPLY AND MASTER SECTION
2
1
3 2-TRACK IN
Unbalanced line input with RCA L/R sockets.
Connect to this socket the output of a hi- equipment (CD) or other device
with RCA outputs.
4 2-TRACK OUT
Unbalanced line output with RCA L/R sockets.
Connect these outputs to a hi- device, e. g. a recorder; the output level
is set by MAIN MIX control.
5 DFX MUTE
Footswitch 6.35 mm. (1/4”) TS socket. It allows to mute the internal
effects unit using a footswitch.
6 STEREO RETURN
Two 6.35 mm. (1/4”) ouput sockets. Connect these inputs to the outputs
of an external effects or a further stereo device. xxx
7 CONTROL ROOM
CONTROL ROOM output with two 6.35 mm. (1/4”) line sockets.
This output allows you to connect a second set of powered speakers with
independent level control from the master, thus creating two separate
listening zones with different volumes. In recording studio applications
the typical use is for studio monitors. This output volume is adjusted by
the knob PHONES - CTRL/ROOM, regardless of the amount of the MAIN
MIX outputs.
8 DFX OUT
6.35 mm. (1/4”) ouput socket.
Connect this output to your external effects units, if any.
The output signal is the sum determined by the DFX sends for each channel.
9 PHONES
Output for connection to an headphones with 6,35mm. (1/4”) jack.
WARNING: Carefully adjust the volume of PHONES CTRL/ROOM knob,
thus avoiding temporary or permanent damage to your hearing
10 MAIN MIX OUT
Two 6.35 mm. (1/4”) output sockets. Connect these outputs to the inputs
of your sound system.
3
6 10
8
4
7 9
5