User Manual

Antaira Industrial Ethernet Switches
LMX-0601G-SFP Series User Manual V1.1
8
2.6 Cabling
 Twisted-pair segments can be connected with an unshielded twisted pair (UTP) or shielded
twisted pair (STP) cable. The cable must comply with the IEEE 802.3u 100Base TX
standard (e.g. Category 5, 5e, or 6). The cable between the equipment and the link partner
(switch, hub, workstation, etc.) must be less than 100 meters (328 ft.) long.
 Fiber segment – port 6: dual rate (100/1000) SFP slot. The small form-factor pluggable
(SFP) is a compact optical transceiver used in optical communications for both
telecommunication and data communication applications.
 To connect the transceiver and LC cable, please follow below steps:
 First, insert the SFP transceiver module into the SFP slot as shown below in Figure
2.9. Notice that the triangle mark is at the bottom of the SFP slot. Figure 2.10 shows
SFP transceiver module was inserted.
Figure 2.9 - Transceiver to the SFP Module
Figure 2.10 - Transceiver Inserted