User Manual

Antaira Industrial Ethernet Switches
LMX-0601G-SFP Series User Manual V1.1
24
Terms Value Description
Protocol “Enable” or “Disable” ERPS protocol
Ring Port 0
ERPS ring port 0, can be mapped to port 1 – port 6.
Do not set the same as Ring port 1.
Ring Port 1 ERPS ring port 0, can be mapped to port 1 – port 6.
Do not set the same as Ring port 0.
Role
Set the ERPS role as Owner, Neighbor or Normal.
[Owner] In charge of blocking one side of RPL link. It will prevent the packet
flow from its blocked port.
[Neighbor] In charge of blocking one side of RPL link. It will prevent the
packet flow from its blocked port.
[Normal] Besides Owner and Neighbor node, the rest of nodes are defined
as Normal node.
All node roles have the ability to block the port if the link attach to the port is
failed and disconnected.
Ring ID
ERPS ring ID, ranges from 1 to 239. Ring ID distinguishes different Ring
topology.
Channel ERPS Channel ID, ranges from 1 to 4094. It’s a channel to send PDUs of
ERPS.
Revertive Set to Revertive (yes) or Non-revertive (no). The revertive mode works only
under scenario A at the RPL Owner node.
[Revertive] While the revertive mode is set, the RPL link will be blocked in 5
minutes after recovery form link failure situation. Otherwise, it will remain
unchanged of the blocking state. That is, the failed link port will block
permanently until the next event happen.
[Non-Revertive] The failed ring link the port attached to it will remain blocked
even the situation is eliminated.
Click the “Apply” button to save changes.
Figure 5.16 – ERPS Configuration Terms & Description