Manualshelf

User Manual

ManualsBrandsAntaira Technologies ManualsComputers & AccessoriesAntaira LNX-2602G-SFP Industrial 26-Port Unmanaged Gigabit Ethernet Switch, 2 SFP Slots, DIN-Rail Mount, -10 to 70°C Operating Temperature, AC Power Input
9101112131415161718
Antaira Technologies - Industrial Ethernet Switches
LNX-2602G-SFP Series User Manual V1.0
9
3. Mounting Installation
3.1 Rack Mounting
The switch comes with a rack-mounted kit can be mounted in an EIA standard size, 19-inch rack.
It can be placed in a wiring closet with other equipment.
Perform the following steps to rack-mount the switch.
1. Position one plate to align with the holes on one side of the hub and secure it with the smaller
plate screws. Then, attach the remaining plate to the other side of the switch.
2. After attaching both mounting plates, position the switch in the rack by lining up the holes in
the plates with the appropriate holes on the rack. Secure the switch to the rack with a
screwdriver and the rack-mounting screws.
*Note: For proper ventilation, allow at least 4 inches (10 cm) of clearance on the front and 3.4
inches (8 cm) on the back of the switch. This is especially important for enclosed rack installation.
Figure 3.2 – Mount the Switch in an EIA Standard 19-inch Rack
Figure 3.1 – Attach Mounting Plates with Screws