Installation Manual

3
4
P1 P2 Fault
10/100/
1000T
1
2
7
8
5
6
Practical Operation
Q I G
Quick Installation Guide
LNP-800AGH-24
LNP-800AGH-24
Version 1.2
Quick Installation Guide
Features
The LNP-800AGH-24 is an unmanaged Gigabit PoE Ethernet switch with P.S.E.
Function. The LNP-800AGH-24 supports Power over Ethernet, a system to
transmit electrical power, along with data, to remote devices over standard twisted-pair
cable in an Ethernet network. The LNP-800AGH-24 supports wide range
12~36VDC power inputs and generates 50VDC P.S.E. power output per port. The
LNP-800AGH-24 PoE switch has 8 x 10/100/1000Base-T(X) P.S.E. (Power
Sourcing Equipment) ports. P.S.E. is a device (switch or hub for instance) that
will provide power in a PoE setup. The wide operating temperature range from -
o o
40 C to 70 C (LNP-800AGH-24-T) can satisfy most operating environments.
Therefore, the switch is one of the most reliable choices for PoE Ethernet application.
Introduction
Specifications
Model
Physical Ports
Technology
Ethernet Standards
LED Indicators
Green: Power LED x2Power indicator
10/100/1000Base-T( X) P.S.E.
Port in RJ45 Auto MDI/MDIX
LNP-800AGH-24 / LNP-800AGH-24-T
8
IEEE 802.3 for 10Base-T
IEEE 802.3u for 100Base-TX
IEEE 802.3ab for 1000Base-T
IEEE 802.3x for Flow control
IEEE 802.3at PoE specification
MAC Ta ble
4096 MA C addresses
Environmental
o o
-40 to 85 C (-40 to 185 F)Storage Temp erature
Operating Temperature
5% to 95% N on-condensingOperating Humidity
Regulatory Approvals
FCC Part 15, CISPR (EN5 5022) class AEMI
EN61000-4-2 (ESD), EN6100 0-4-3 (RS), EN61000 -4-4 (EFT), EN61000-4- 5 (Surge),
EN61000-4-6 (CS), EN61000-4-8, EN61000-4-1 1
EMS
IEC60068-2-27Shock
IEC60068-2-32
IEC60068-2-6Vibration
Free Fall
Warranty
5 yea rs
-10 to 60
o
C (14 to 140
o
F) Standard Model
-40 to 75
o
C (-40 to 167
o
F) Extended Operating Temperature Model
Amber : Indicate PWR1 or PWR2 failure
Fault i ndicator
Fault contact
Relay
Relay output to carr y capacity of 1A at 24 VDC
Power
Redundant Input powe r
Power consumption( Typ.)
7.8 Watts
Overload current protec tion
Reverse polarity protection
Prese nt
Not Pre sent
Physical Characteristic
Enclos ure
IP30
Dimension (W x D x H)
Weight (g)
452 g
Dual DC i nputs 12-36VDC on 6-p in terminal block
@12VDC for 90W PoE Power Budget, @24-36VDC for 200W PoE Power Budget
41(W) x94.9(D)x144.3( H) mm (1.62x3.74x5. 68inch.)
10/10 0/1000Base-T(X)
port in dicator
RJ45
Green for port Link/Act.
Green for PoE power injected.
The LNP-800AGH-24 can be used in connecting several PoE P.D. Ethernet devices like
IP-Camera or other Ethernet devices. In addition, there are two different power
inputs at terminal block to avoid interruption caused by power down. When the
primary DC power input fails, the backup power input will take over immediately to
guarantee a non-stop operation.
Industrial Unmanaged Gigabit PoE Switch
PRINTED ON RECYCLED PAPER
EN60950-1, UL Class 1 Division 2Safety
Provide 8x10/100/1000Base-T(X) PoE (P.S.E.) ports
Support P.S.E. compliant with on IEEE 802.3at standard up to 30 Watts per port
Support dual wide range 12~36VDC power inputs for power redundancy
Support auto-negotiation and auto-MDI/MDI-X
Support store and forward transmission
Support flow control
Rigid IP-30 housing design
DIN-Rail and wall mounting enabled
Power Connection Guide
Frame Ground
G
Power
Supply
12-36VDC
V+
V-
Warning
Device
GND+24V
V+
V-
DIP Switch Select for
Power Alarm Relay Output
Power
Supply
12-36 VDC
Power
Supply
DIP-2
OFF
OFF
ON
DIP-1
Power failure relay alarm disabled
PWR-1 failure, alarm enabledrelay
PWR-2 failure, alarm enabledrelay
DIP Switch Function
OFF
ON
OFF
Description
DIP-Switch
Power-1 failed warning : (ON) enable, ( OFF) disableDIP-Switch 1
Power-2 failed warning : (ON) enable, ( OFF) disable
DIP-Switch 2
Power LED
Power Fault LED
A
Gigabit LAN Port
Green: PoE power injected
Green: Link/Act
ON
PWR-1 or PWR-2 failure,
relay alarm enabled
ON
PWR-1PWR-2
V2- V2+ V1- V1+
1A@24V
Check Pol ar it y First.
Warn ing !!!
12-36Vd c In pu t only
Proce ssing
Store -and-Forward
Front Panel
GI GA BI T
I N D U S T R I A L
SW IT C H
Po E

Summary of content (2 pages)