Owner`s manual

T.C.
WHITLOCK 89201257 GEARBOX WRG11
WITH ARM AND STOPS AS SUPPLIED
2°
1/4" (8mm)
WITH RUDDER AMIDSHIPS,
SECURE TILLER ARM WITH
PIN DISPLACED OUTBOARD
AS INDICATED
39°
33°
WELDED STOP
BLOCKS
VESSEL
CENTRE
LINE
17" (431mm)
GEARBOX STOP PLATES
VIEW LOOKING FORWARD
65°65°
STBD. TIE ROD,
NOMINAL LENGTH 78-3/4" (2000mm) PIN TO PIN
INTERMEDIATE TORQUE TUBE
126-1/2" (3213mm) PIN AXIS TO PIN AXIS
CONFIRM ALL DIMENSIONS FOR TORQUE TUBES
AND TIE RODS ON VESSEL AS BUILT.
ANTARES 44 STEERING
STEERING LAYOUT JEFA
SS-04-08
SHEET 1 OF 2
ISSUED NOV. 10, 2010
FIRST VESSEL USED 4437
4°
1/2" (12mm)
32°
39°
IN A TURN, THE INSIDE RUDDER HAS SMALLER TURNING RADIUS
THAN THE OUTSIDE RUDDER, APPROXIMATELY
CORRESPONDING TO THE VESSEL'S TURNING CENTRE.
TO ACCOMODATE THIS, 6-7 DEG. OF ACKERMAN ANGLE
IS ACHIEVED WITH TILLER ARMS INSTALLED AT AN OUTBOARD
ANGLE IN RELATION TO MIDSHIPS RUDDERS AND GEARBOX
ARM CONFIGURED AS SUPPLIED.
WITH RUDDER AMIDSHIPS,
SECURE TILLER ARM WITH
PIN DISPLACED OUTBOARD
AS INDICATED
PORT TIE ROD,
NOMINAL LENGTH 112-1/2" (2857mm) PIN TO PIN
NOTE:
CONFIRM CLEARANCE BETWEEN
TORQUE TUBE AND DECK MOULDING WHEN
MOUNTING HELM AND AUTOPILOT
GEARBOXES
STEERING CONSOLE FRP BULKHEAD
HELM TORQUE TUBE
40-3/8" (1025mm) PIN AXIS TO PIN AXIS
JEFA STD.
BRAKE SPINNER
JEFA BULKHEAD MOUNT HELM GEARBOX
BG15S - 10 SERIES 1.5:1 STEERING BEVELHEAD
WITH MOUNTING FLANGE & FASCIA PLT. 55000
NOTE UNIVERSAL JOINT AXIS
COMMON TO BOTH ENDS
NOTE POSITION
OF CLAMP HALF
OVER SPLIT
IN HUB
JEFA UJ10
UNIVERSAL
JOINT
CLAMP BOLTS
SECURES JOINT TO
GEARBOX SHAFT
JEFA TT10-XXX
TORQUE TUBE
EXTRUSION
FOR CROSS
BEARING
SERVICE ONLY
OVAL BORE
FITS GEARBOX
SHAFTS
CLAMP BOLTS
SECURE TUBE
TORQUE ALL FASTERS AND
SECURE WITH LOCKTITE
LOCKING JAMB NUT
JEFA ROSE JOINT
TLPIN16
1-1/2" (40mm) ALUM TUBE
JEFA DLXXXXXX-40
TYPICAL TIE ROD
TUBE END ASSEMBLY
TYPICAL TORQUE
TUBE ASSEMBLY
INTERMEDIATE TORQUE TUBE
PASSES THROUGH AFT BULKHEAD
AND COCKPIT SUPPORT BULKHEAD
JEFA BEVEL GEARBOX
BG13 - 10 SERIES 1.2:1