User Manual

52
Tutorial 3: Natural Vibrato Function
This tutorial will demonstrate the use of the
Natural Vibrato function using the same audio
file we used in the previous tutorial.
Begin the tutorial by doing the following:
1. Load or import “wide_vibrato” into a track
of your host program. This is a recording of
a male voice singing a sustained “G” with
a pronounced vibrato. Play the track so that
you are familiar with the original audio.
2. Set up Auto-Tune Evo to be an insert effect
on that track.
3. Set Auto-Tune Evo to Automatic Mode.
4. Set the Key to “C” and the Scale to
“Chromatic.”
5. Set the Input Type to Low Male Voice
6. Set Retune Speed to a value of 24.
7. Set “wide_vibrato” to loop continuously
and put your host program into Play mode.
8. Set Natural Vibrato to 12 and note the
effect on the vibrato. Set Natural Vibrato to
-12 and note the effect on the vibrato.
9. Set all Scale notes to Bypass to disable
any pitch correction. Again, adjust Natural
Vibrato as in Step 8 and note that its effect
is still active.