User Manual

33
on the track of the Control Signal. ARTICULATOR
Evo’s internal Noise Generator functions as
the Audio Signal. (This is useful primarily for
whispering and modulated noise effects.)
Instantiation on a stereo
track: In this configuration,
ARTICULATOR Evo treats
the right channel of the stereo
track as the Control Signal
and the left channel of the
track as the Audio Signal.
As is probably obvious, this will
usually require that you create
the stereo track by combining
(via whatever method your
DAW provides) the two
independent tracks you wish to
use as Control Signal and Audio
Signal (being careful to ensure
that they are hard panned to
the appropriate channels).
In this configuration, the Audio Signal is limited to
being mono (although it can be combined with
the Noise Generator in Stereo Noise mode).
Instantiation on a 3 channel
FX bus: In this configuration,
ARTICULATOR Evo treats
the surround channel of the
FX bus as the Control Signal
and the left and right stereo
channels as the Audio Signal.
Again, this will require that you
create the FX bus channels by
combining the independent
tracks you wish to use as
Control Signal and Audio Signal
(again being careful to ensure
that they are hard panned to
the appropriate channels).
This is the most flexible of the
three options, in that it allows
you to process a stereo Audio
Signal.
AUDIO UNITS Some Audio Units hosts
support sidechain input and some don’t.
Consequently, the Input Routing section for the
AU version provides controls that allow you to
set up ARTICULATOR Evo to take advantage of
whichever capabilities your host provides.
The Input Routing section will
change to reflect each of the
two possible options:
Instantiation on a mono
track: In this configuration, you
can select either the sidechain
input or the audio track itself as
the Control Signal. If our host
supports sidechain input, you
will typically always select it
as the Control Signal. If your
host does not offer sidechain
input, select Audio Track.
Depending on your choice,
the resulting Audio Signal
source will appear in the Audio
Signal display as follows:
•
If you select Sidechain, the Audio Source will
be the audio track that ARTICULATOR Evo is
instantiated on.
•
If you select Audio Track, ARTICULATOR
Evo’s internal Noise Generator functions as
the Audio Signal. (This is useful primarily for
whispering and modulated noise effects.)
Instantiation on a stereo track: In this
configuration, you can select
either the sidechain input or the
left channel of the audio track
or the right channel of the audio
track as the Control Signal. If
our host supports sidechain
input, you will typically always
select it as the Control Signal.
If your host does not offer
sidechain input, select either
the left or right channel of the
audio track.
Depending on your choice, the
resulting Audio Signal source
will appear in the Audio Signal
display as follows: