User Guide

Auto-Tune UserÕs Manual 27
Lesson 2: Graphical Mode
3. Play back the sound to hear the effect.
4. Select the Curve tool, then click and hold down the mouse on the Pitch
Graph. A curve will be drawn as the mouse is dragged. To exit, lift up on
the mouse. Create a curve similar to the one shown:
5. Play back the sound to hear the effect.
6. Listen to the effect of the Retune slider as you change the values
between 0 and about 50.
7. Experiment with the Pointer tool. This tool is used to select and drag
lines and curves.
Clicking on white space in the Pitch Graph causes all objects to become
de-selected. Clicking on white space and dragging causes object end
points to become selected. Shift-clicking (and dragging) is used to select
contiguous points. Dragging off the Pitch Graph automatically scrolls the
graph.
Every line or curve has two end points. If both end points are selected,
the object is said to be selected. If you click on an object which is not
selected, it becomes selected. If you click on an object that is already
selected, it (and anything else that is selected) stays selected so you can
drag it.
Dragging causes the selected objects to be moved. Any objects that
have one end-point selected will be stretched during dragging. Dragging
is constrained by neighboring unselected objects.