User Manual

5
If you wish to pair additional wireless transmitters on the same fan, please follow the
instructions below:
1. Plug in the fan.
2. Set DIP switch no. 10 to position OFF.
3. And then set DIP switch no. 10 to position ON. At this moment, the red light is on for
about 10 seconds. During the 10 seconds, you can press any button (A or B) on the
transmitter to pair it. When the wireless receiver has the signal, the green light will
flash to confirm the registration.
4. When the light starts flashing green, the wireless transmitters are good to go.
Please note that wireless remote function is optional, and it is only applicable to AF-3R or
AF-3XR versions.
Z-3 Remote Control Operation (Optional)
To operate the machine by remote control, connect the remote to the microphone jack
located on the rear of machine. Use the switch to turn wind on/off, and use the rotary knob
to adjust the output volume from 0~100%.
3. DMX Control
DMX Connector Pin Assignment
The machine provides 3-pin or 5-pin XLR connectors for DMX connection. Please advise
the DMX specifications requested while ordering. The diagram below indicates pin
assignment information.