Owner's manual

Antari HZ-100, HZ-300 and HZ-400 Haze machines produce safe, dry clean and virtually

invisible haze when used with HZL-1 Haze liquid with an extremely long hanging time.

For ideal results, haze when touch-up is needed.

•Caution

1. Always monitor and make sure that there is sufficient HZL liquid inside the tank during

operation.

2. Pour hazer liquid into the liquid tank about 1/2 full, be careful not to exceed the

maximum fluid level. DO NOT OVERFILL. The extra 1/2 tank space is reserved for

air-flow purpose. Overfilling will cause the unbalance in air pressure which will affect

the haze liquid to flow back to the compressor and may lead damage of the

compressor unit.

3. When the machine is operated for a longer period of time under open-air conditions,

falling dust/debris can enter the machine and may create residue inside the muffler of

the compressor. It will clog the filtration fibre on the muffler. Contact an authorized

Antari dealer to replace a new muffler only (please note that the old muffler is unable to

use repeatedly after washing or brushing). Long term use of the unit which has the

build-up residue on the muffler may cause an unsteady operation of the compressor. It

may even cause danger of burn under serious conditions.

4. If you have followed the above operation steps, and you still experience low output,

mechanical noise or no output at all, unplug the unit immediately from the mains.

Check the fluid level, the external fuse, the remote control connection, and the power

cable from the wall. If all of the above appears to be O.K., plug the unit in again. If the

hazer still does not function, discontinue operation or it may result in permanent

damage to the unit. Return the machine to your Antari dealer. Always drain tank

before mailing or transporting this unit.