W-101 Bubble Machine User Manual Please read and save these instructions. ©2009 Antari Lighting and Effects Ltd.
Page>01 Page>08 Page>16 Page>28
User Manual W-101 Bubble Machine Congratulations on the purchase of your new ANTARI W-Series bubble MACHINE. Introduction Thank you for choosing an Antari W-Series Bubble Machine. You now own a rugged and powerful state-of-the-art bubble machine. Prior to use, we suggest that you carefully read all of the instructions. By following the suggestions found in this user manual, you can look forward to the reliable and satisfactory performance of your Antari Bubble Machine for years to come.
For inside use only. Not designed for outside use. This appliance must be earthed. For adult use only. The bubble machine must be installed out of the reach of children. Never leave the unit running unattended. Never aim the output nozzle at open flames. Extended use will make all surfaces slippery. Please kindly pay attention. Position the output of bubbles away from people. Switch off from mains when refilling the liquid or cleaning the system. Regular cleaning of the bubble wheel is required.
- Always replace the caps on the liquid container immediately after filling to avoid contamination. W-101 Hanging Bracket: Your model includes a mounting bracket designed for overhead installation; it may be installed at floor level or suspended overhead. If the unit is to be mounted using the bracket, it is important that the bubbles do not shoot directly at anyone's face. Whatever installation method you choose, do not allow the unit to have more than a 25 degree angle of inclination.
Safety Screw Finger Screw To help avoid accidental exposure to dangerous live AC mains voltage, two safety screws are fitted that require a screw driver to remove. Once these are removed, the finger screws can be undone by hand (see photo above). Once the screws are removed, the lid of the housing can be carefully swung upwards, as shown above. Take care not to spill any of the bubble fluid inside the unit. The fluid tank is designed to fit only one way around.
produces bubbles. For wireless operation with the W-1, set the power switch to “Wireless Mode”. Now please refer to chapter “W-1 Wireless Remote” for setting the remote control. W-1 Wireless Remote The wireless remote control system W-1 consists of a transmitter equipped with two buttons for bubbles on and off, and a receiver pre-attached to the rear panel of each W-series model. * Transmitter: With the transmitter it is possible to emit bubbles via radio over a distance of up to 50 meters.
- Registering transmitters: To operate the machine with a different transmitter than the included one, or to operate it with up to 5 different transmitters, each transmitter must be registered first. There is an LED light on the rear control panel of the machine. When the machine is turned on, the green LED will be flashing for 15 seconds. During the 15-second interval, users can register signals for one or more transmitters. For this purpose, press the button “A” on each transmitter.
Approval This product is in accordance with the R&TTE directive (Radio and Telecommunication Technical Equipment) of the European Union and falls into equipment Class 1. In all EU member countries, the operation of this wireless system is generally approved by the national telecom regulatory authority. The system is license-free. In some countries outside the EU, the operation of this wireless system may needs to be approved by the national telecoms regulatory authority.