Instruction Manual

13
 Z-10, Z-40, Z-50 Remote Controllers
 Performance Note
 All fog machines develop condensation around the output nozzle. Because this may
result in some moisture accumulation on the surface below the output nozzle, consider
this condensation when installing your unit.
 All fog machines may sputter small amounts of fog occasionally during operation and for
a minute or so after being turned off.
 Maintenance
Do not allow the fog liquid to become contaminated. Always replace the caps on the fog
liquid container and the fog machine liquid tank immediately after filling. After every 40 hours
of operation, it is recommended to use distilled water to run a cleaning process.
The recommended cleaning regimen is as follows:
1. Empty all fog liquid from the machine. Add distilled water to liquid tank. Plug unit in and
begin warm up.
2. Run the unit in a well-ventilated area and run the fog machine briefly. Do not allow the
pump to run dry.
3. Cleaning is now completed. Empty the water left inside liquid tank and refill with fog liquid.
Run the machine briefly again.