Z-1520 RGB Fog Machine User Manual English © 2014 Antari Lighting and Effects Ltd.
User Manual - English Safety Information Please read the following safety information carefully before operating the machine. Information includes important safety information about installation, usage, and maintenance. Pay attention to all warning labels and instructions in this manual and printed on the machine. If you have questions about how to operate the machine safely, please contact your local Antari dealer for help. ․ Keep this device dry.
․ Before transporting the machine, make sure the fluid tank is completely drained. ․ Smoke fluid may present health risks if swallowed. Do not drink smoke fluid. Store it securely. In case of eye contact or if fluid is swallowed immediately look for medical advice. Unpacking and Inspection Immediately upon receiving the machine, carefully unpack the carton, check all content to ensure that all parts are present and have been received in good condition.
Product Overview XLR 5-Pin DMX Connector XLR 3-Pin DMX Connector PowerCon Breaker Tank Capacity : 2.5 liter Wireless Receiver LCD Control Panel 22 x 3W LED (8R, 7G, 7B) Setting Up Step 1: Place the machine on a flat surface and in a suitable large area with at least 50 cm open space around the machine. Step 2: Fill the fluid tank with Antari approved fluid. Step 3: Connect the machine to suitable rated power supply.
Fog”. Now the machine is ready for operation. Step 5: To start making fog, locate the Volume button on the control panel, and press the button to start making fog. Step 6: To turn off the machine, press STOP button and turn Powercon to the OFF position.
Color Mode On Turn LED On or Off Color Mode Marco:01 Color Mode Chase:01 Timer Set LED output color from macro 1 to 10 Set LED chase from 1 to 15 Set interval from 15 to 360 seconds Interval 15 Sec Timer Set duration from 1 to 5 seconds Duration 5 Sec Wireless Setting Turn On or Off wireless control On Wireless Setting Button A:M01 Wireless Setting Button B:M01 Wireless Setting Button C:M01 Wireless Setting Button D:M01 Set wireless remote button function macro color 1 to 10 or chase 1 to 1
Setting for LED to turn on with fog only or always on. LED Setting Fog Only Set LED delay time from 0 to 5 seconds. LED Fade Out Delay: 0 Sec Run Last Setting Turn On/Off run last setting function On Wireless Operation Wireless remote control system W-2 consist of a transmitter equipped with four buttons to activate four user configurable LED setting and fog; with an onboard receiver attach to the rear panel of Z-1520 RGB.
section to setup each buttons. In a free open space the effective distance is 50 meters, actual usage depending on obstacle level the effective distance is 10-25 meters. Registering transmitter Transmitter can be pair or deleted from the receiver. Each receiver can pair up to 10 transmitters. Follow below steps to pair or delete transmitter from receiver.
Pin Function 1 Ground 2 Data- 3 Data+ DMX Channel Function Channel 1 DMX Value Range Function 0–4 Fog Off 5 – 255 Fog On Channel 2 DMX Value Range Function Red LED 0-255 0-100% Channel 3 DMX Value Range Function Green LED 0-255 0-100% Channel 4 DMX Value Range Function Blue LED 0-255 0-100% Channel 5 DMX Value Range Function Chase 1-15 Chase 1 16-31 Chase 2 32-47 Chase 3 48-63 Chase 4 64-79 Chase 5 80-95 Chase 6 96-111 Chase 7 112-127 Chase 8 128-143 Cha
Chase Speed 0-255 0-255 step per min Channel 7 DMX Value Range Function Master Dimmer 0-255 0-100% Channel 8 DMX Value Range Function Strobe 0-255 1-20 Hz Fluid Only use Antari FLC water-based liquid for the Z-1520 RGB Fogger. The machine is tested and calibrated with this liquid to get the best output performance. Warranty will be void if any other type of liquid is used, improper use of liquid may lead to machine failure and malfunction.
Step 1: Disconnect AC power Step 2: Flip breaker to ON position Step 3: Turn on machine to test Breaker 120V = 15A 250V 230V = 9A 250V Technical Specifications Input voltage 120V 60Hz 230V 50Hz Breaker 120V = 15A 250V 230V = 9A 250V Heater 1550W Warm-up time 5 min. (approx.) Coverage volume Height 5 Meters, Width 1 Meter Max. operating time 8 seconds burst Fluid tank capacity 2.4 L Fluid consumption 25 ml/10 sec.
C08Z15200 12
