User Manual for the Antari M-1 Mobile Fog Machine Save and read these instructions Bitte lesen Sie und sichern Sie diese Anweisungen Lisez et Gardez ces instructions
M-1 Mobile Fogger Thank you for choosing Antari’s M-1 Mobile Fogger. You now own a sturdy and portable state-of-the-art fog machine. Prior to use, we suggest that you carefully read all of the instructions. By following the suggestions found in this user manual, you can look forward to exceptional performance from your Antari Mobile Fog Machine for years to come. Please follow these operation, safety and maintenance instructions to ensure a long and safe life for your fog machine.
This machine is not waterproof or splash proof. If moisture, water, or fog liquid gets inside the housing, immediately remove power and contact a service technician or your Antari dealer before using it again. No user serviceable parts inside. Refer to your Antari dealer or other qualified service personnel. Danger of burns For adult use only. Fog machine must be installed out of the reach of children. Never leave the unit running unattended. Keep nozzle at least 50 cm (20 in.
Always drain fog liquid from the tank before shipping or transporting this unit. Never drink fog liquid. If it is ingested, call a doctor immediately. If fog liquid comes in contact with skin or eyes, rinse thoroughly with water. Unpacking & Inspection Open the shipping carton and check that all equipment necessary to operate the system has arrived intact. In addition to this user manual, you should receive the following items: 1. M-1 Mobile fogger 2. 12V – 2.3Ah rechargeable battery 3.
Plug the charged battery into the bottom of the M-1 Mobile Fogger with the label face up. 1. Lift-up the plate before inserting the battery. 2. Make sure the battery is inserted on the right position (see photo). The green light by the front of the handle will flash when the button is first pressed. This indicates the battery has enough charge to power the M-1. When the red light starts to flash, the battery needs to be charged.
To select operation mode 1. Slide the switch towards the back of the M-1 (towards the cap on the liquid tank). To select operation mode 2. Slide the switch towards the front of the M-1 (towards the nozzle). When an optional remote is connected, please see the detailed instructions for their operation below. The machine will fog until the battery charge runs down or the M-1 runs out of fog liquid.
There are two optional remote controls designed for the M-1 Mobile Fogger. 1. MCT-1 Timer Remote Control: This remote control is connected via an 8-meter cord. The duration of the fog blast is set at 10 seconds. The interval is controlled by the dial on the remote and is adjustable between 3 and 220 seconds. 2. MCR-1 Wireless Remote Control: This remote control consists of two components. The transmitter is on a small key chain and has a range of up to 50 meters from the receiver.
Always monitor tank fluid level as you are fogging. Running a fog machine with no fluid can permanently damage the unit. If you experience low output, pump noise or no output at all, remove the battery immediately. Check fluid level and re-charge the battery. When the liquid tank is full and the battery is charged, plug the battery in and press the button on the handle.
