User manual

6
 To select operation mode 1. Slide the switch towards the back of
the M-1 (towards the cap on the liquid tank).
 To select operation mode 2. Slide the switch towards the front of
the M-1 (towards the nozzle).
 When an optional remote is connected, please see the detailed
instructions for their operation below.
 The machine will fog until the battery charge runs down or the M-1
runs out of fog liquid. When the M-1 is connected to the optional
power adaptor, carefully monitor the level of the fog liquid to make sure
the machine does not run out of liquid. Operating continuously, the
machine will run out of liquid in approximately 50 minutes.
 A full battery charge will power the M-1 for a period of 10-12 minutes
before needing to be recharged. When using the battery, the charge
will run down several times before the fluid needs to be refilled.
Note: There is no warm-up time with the M-1 Mobile Fogger. Unlike
most other fog machines, you do not have to wait for the heater to
warm-up before fogging.
Installation
 The M-1 Mobile Fogger can be carried in hand or installed in a fixed
location as desired.
 Wherever the machine is placed, it is important that fog does not shoot
directly at any one’s face, at open flames or directly into any heat
susceptible material.
 The machine can be held or installed at any angle. After refilling the
liquid tank, screw the cap on tightly. Failing to do so will result in
leakage if the machine is placed at an angle.
Optional Remote Control Operation