User manual

3
" The output nozzle becomes very hot during operation (300 degrees C). Keep
flammable materials at least 50 cm away from the nozzle.
" Always allow your Antari Fog Machine to cool down before attempting to clean or
service it.
Danger of explosion
" Never add flammable liquids of any kind (oil, gas, perfume) to the fog liquid.
" Use only the high-quality, water-based fog liquid that your Antari dealer recommends.
Other fog liquids may cause poor effect fog, clogging and “spitting” of unevaporated
liquid.
" Always make sure there is sufficient liquid in the fog liquid tank. Operating this unit
without liquid will cause damage to the pump and the heater.
" If your Antari Fog Machine fails to work properly, discontinue use immediately. Drain
all fog liquid from the tank, pack the unit securely (preferably in the original packing
material), and return it to your Antari dealer for service.
" Always drain tank before shipping or otherwise transporting this unit.
" Never drink fog liquid. If it is ingested, call a doctor immediately. If fog liquid comes in
contact with skin or eyes, rinse thoroughly with water.
Unpacking & Inspection
Open the shipping carton and check that all equipment necessary to operate the system
has arrived intact. In addition to the F-80Z, you should receive the following items:
1. FCW-80Z wired remote
2. Hanging bracket
3. 800 ml (1 quart) Liquid tank.
" Before beginning initial setup of your Antari Fog Machine, make sure that there is no
evident damage caused by transportation.
" In the event that the unit’s housing or cable is damaged, do not plug it in and do not
attempt to use it until after contacting your Antari dealer for assistance.
Setup
" Remove all packing materials from the fog machine. Check that all foam and plastic
padding is removed, especially in the nozzle area.
" Fill with Antari Fog Liquid or other high-quality water-based fog fluid. Any other types
of fluid can damage the unit. When filled, place cap back on liquid tank.
" Firmly attach the remote control cable to the proper input on the rear of the machine.
Operation
" Plug power cord into a grounded electrical outlet. If necessary, turn power switch on
rear of unit to “ON” position. Warm-up is complete when green lamp lights up on
remote unit.
" To emit fog, press the button on the remote and hold for the desired length of time.
" The remote unit’s lamp will cycle on and off as the machine re-heats to the proper
operating temperature.
" For further information on operating your Antari Fog Machine, see the section titled,
“Remote Control Operation”.
Installation