User manual

Getting Started
Please fully charge SP1 before initial use. Connect the included
Micro-USB cable to your SP1 and a USB slot of any PC or Mac to
charge. The RED LED will turn on while charging and will turn off
when fully charged.
Push and hold the center button for 6-8 seconds until the LED
constantly flashes white. You are now in Pairing Mode. See your
phone/music device manual for pairing instructions.
Pairing Mode
Connections
Socializing
Start Listening
LED Indicator
You may connect to your device wirelessly via Bluetooth or use a 3.5
mm stereo input cable.
The SP1 can be used as a wireless speakerphone. The built-in
microphone will only function under wireless connectivity via Bluetooth.
For optimal sound, place SP1 on its base (with the a.m.p. label on the
bottom) and faced towards you (with the SP1 label read from left to right).
When connected via Bluetooth, it’s best to have the phone volume
turned fully up and use the “+” and “-“ buttons that are located on the
top of your SP1.
If you decide to use the 3.5 mm function, please make sure that the
SP1’s volume is turned down before operation. This will reduce the
tendency to overdrive the speaker’s units causing distortion to the audio.
EN EN
LED Color Description
Flashing Red Low Battery
Alternating Red and White
Charging
Solid White Fully Charged
Flashing White Pairing Mode
Volume down
Volume up
Center Button