User Manual

Zen Tour Synergy Core User Manual 27
Tap to enable/disable S/PDIF sample rate conversion. For example, if your S/PDIF source
is outputting 44.1kHz audio and the interface is set to 96kHz, the S/PDIF audio will be
sample rate-converted to 96kHz.
Presets Saving
Tap to save the current device and session settings into one of the 5 available preset slots.
Tap 'P1' - 'P5' (bottom row) to recall presets 1 - 5.
Antelope Button
Lets you assign the Antelope Button on the interface's top panel to one of the following:
● Monitor Mono - sum monitor outputs to mono.
● Mon Dim (latch) – press the button to 'dim' the monitor outputs. Press again to
undo.
● Mon Dim (hold) – press-and-hold the button to 'dim' the monitor outputs. Release
to undo.
Touch Scr Calib
Calibrate your screen from here. Simply tap on the blue dots that appear on the screen to
make sure your touchscreen is properly calibrated. In the events of non-responsive screen,
hold GAIN and ANTELOPE button to perform the same operation.
Clock Source
Tap 'INT' (the third button from left to right, top-most section) to choose the clock
source. The following choices are available:
● 'Internal' - Internal Clock
● ‘S/PDIF’ input (external)
● ADAT (2x, 4x) input (external)
● 'USB' - In ‘USB’ mode the unit still uses its internal clock.