User Manual

Zen Tour Synergy Core User Manual 28
Additional Functionality
● Tap 'POWER' to power off the interface. Tap again to confirm.
● The 'LOCK' indicator indicates when the interface is locked to an external device or
DAW.
● Tap the Sample Rate indicator (immediately after 'Clock Source') to change the
device sample rate. Please make sure your choice matches the DAW and operating
system sample rates.
'MON' Button
Tap 'MON' to enter Monitor Volume. The following functionality is available:
● Tap the left and right arrows to 'cycle' the analog outputs.
● Tap '24 dBu' to adjust signal trim in preset dBu values.
● Tap, hold and drag the circle to adjust volume in dB. You can also do this from the
main rotary control knob.
● Tap the 'Speaker' symbol to mute or un-mute the outputs.
● Tapping 'LINE' or 'HP' takes you to the 'Line Out Volume' and 'HP1/HP2 Volume'
pages, respectively. The functionality is identical.
'AMP' Button
Tap 'AMP' to enter gain adjustments for the Hi-Z/mic preamp/line inputs. The following
functionality is available:
● Tap the left and right arrows to cycle the inputs.
● Tap 'Mic' to choose the input signal type:
- Mic (microphone input)
- Line (line-level input)
● Tap, hold and drag the circle to adjust volume in dB. You can also do this from the
main rotary control knob.
● Tap the 'Speaker' symbol to mute or un-mute the input.