User Manual

Zen Tour Synergy Core User Manual 30
Quick Start
Let’s begin with some quick examples of essential tasks being accomplished in the Control
Panel.
Note: These examples do not convey the "correct" or "only" way of accomplishing the
following tasks. They merely present some fundamental logic and offer solutions to the
initial stumbling blocks most often encountered by new users.
Monitor incoming audio via headphones
Say you want to monitor incoming audio from preamp/combo input A4 via headphones
hooked to HP Output 1. Open the Control Panel and enter the ‘Routing tab’. Drag the
colored number block labeled ‘PREAMP’ 8 onto blocks '1' and '2' from the row labeled ‘HP1’.
Adjust preamp and headphone gain from the Control Panel or the interface's top panel
controls.
Apply Synergy Core FX to incoming audio
Say you want to run audio from preamp/combo input A4 through a custom FX chain while
monitoring the result through your studio monitors.
Open the Control Panel and enter the ‘Routing’ tab. Drag the colored block numbered 8
from the row labeled ‘PREAMP’ onto the colored block numbered 1 in the row labeled ‘AFX
IN’.
Next, drag the colored block numbered 1 from the row labeled ‘AFX OUT’ onto the pair of
blocks labeled 'MONITOR'.
Now, click the ‘Effects’ tab. Add your choice FX by clicking the ‘ADD NEW EFFECT’ drop-
down menu. Listen to your FX-processed audio and play around with the FX parameters.