User Manual

Zen Tour Synergy Core User Manual 53
4. Stack your amps, cabs and FX by clicking the 'ADD NEW EFFECT' button.
5. Hit ‘Play’ in your DAW’s transport controls to hear the sound as you shape your tone.
6. If you want to record the result, route the corresponding ‘AFX OUT’ block onto an
available ‘COMP REC’ output and record from it in your DAW.
Edge & Verge mic emulations
Edge & Verge mic emulations are available on preamp/combo inputs 5 – 8. They are
intended for use with the Antelope Audio Edge & Verge modeling microphones only. We
cannot guarantee optimal (or even usable) results with other microphones.
Before attempting to use mic emulations, make sure of the following:
1. The mic emulations for your modeling microphone are installed from the ‘Software’ tab in
the Antelope Launcher. Install them if they are not.
2. The installed mic emulation bundles are assigned to your Zen Tour Synergy Core.
Getting Started
Mic emulations are accessed by clicking the tiny ‘Mic’ symbol, seen on Channels 5 – 8 in the
‘PREAMPS’ tab.
Gain Calibration
It’s a good idea to connect your mic(s) now and calibrate preamp gain before you proceed.
Click and turn the Gain knobs or double-click the text fields and enter values from the
keyboard.
Gain adjustment for the Edge Solo and Verge is straightforward, but the Edge Duo and
Edge Quadro are multi-membrane microphones. There may be differences in the input
signal strength from each membrane, which may have to be compensated for with
individual gain adjustments.