User Manual

Zen Tour Synergy Core User Manual 55
● Choose mic emulations from the drop-down menu on the right.
● Click and turn the ‘Phase Invert’ dial to flip the microphone’s polarity.
● Click and drag the ‘48’V switch to activate or turn off phantom power.
Recording and Monitoring Edge Solo
Edge Solo is a single-membrane condenser microphone. This means the microphone will
occupy one physical mic preamp input, one block in the Routing Matrix ‘PREAMP’ row, and
one block in the ‘MIC EMU’ row.
Edge Solo mic emulations work on a single input audio channel. Recording and monitoring
both ‘dry’ and ‘mic emulation’ audio means dealing with two mono tracks.
● Route the ‘PREAMP’ input for Edge Solo to your desired outputs to monitor ‘dry’
audio. Route to a ‘COMP REC’ block to record from the corresponding input in your
DAW.
● Route the ‘EMU MIC’ output for Edge Solo (same number as the ‘PREAMP’ input) to
your desired outputs to monitor ‘mic emulation’ audio. Route to a ‘COMP REC’ block
to record from the corresponding input in your DAW.
● Route ‘PREAMP’ and ‘EMU MIC’ blocks to your desired outputs and ‘COMP REC’
channels to monitor and record both ‘dry’ and ‘mic emulation’ audio.
For more information about Edge Solo, visit its
product page.
Edge Duo
Note to owners of the legacy ‘Edge’ modeling microphone: 'Edge' and 'Edge Duo' have
nearly identical hardware, so feel free to use the ‘Edge Duo’ emulations with your legacy
‘Edge’ mic.