User Manual
Table Of Contents
- CONTENTS
- BEFORE YOU BEGIN
- SETTING UP
- ANTELOPE LAUNCHER
- FRONT PANEL EXPLAINED
- REAR PANEL EXPLAINED
- CONTROL PANEL
- Quick Start
- Mouse & Keyboard Shortcuts
- Main View
- Software Re-amping
- Edge Solo
- Edge Duo
- Edge Duo Mic Emulations Window
- Recording and Monitoring Edge Duo
- Recording and monitoring Edge Duo as a single-membrane condenser mic
- Recording and monitoring Edge Duo as a dual-membrane condenser mic
- Recording and monitoring Edge Duo as a modeling microphone
- Recording and monitoring ‘dry’ and ‘mic emulation’ audio simultaneously
- Edge Quadro
- Verge
- ADVANCED USER TIPS
- CUSTOMER SUPPORT INFORMATION
- MY ANTELOPE AUDIO PRODUCT ISN’T WORKING.
- LIMITED WARRANTY POLICY
- Warranty Coverage
- Limited Factory Refurbished (B-stock) Warranty
- Remedies
- Obsolete or Discontinued Products
- Exclusions
- Limitation of Liability
- Data Recovery
- No Other Warranties
- How to Make a Warranty Claim
- Returning Your Product
- Request a Return Material Authorization Number (RMA#)
- RMA Return Addresses
- Products Lost or Damaged During Transit
- Company information
- SAFETY NOTES
- Blank Page
- Getting Started
- Getting Started
- Gain Calibration
- Gain Calibration
Discrete 8 Pro Synergy Core User Manual
Page 24
Peak Meter
Choose the audio source for the peak meters on the display. Up to 32 audio channels are
shown.
Brightness
Dim or illuminate the display.
Monitor Trim
Adjust monitor output signal trim (in dBu).
Line Out Trim
Adjust line output signal trim (in dBu).
Monitor 2 / REAMP
Switch the second pair of analog outputs between 'Monitor Output 2' and 'REAMP
Outputs' mode. Note that in both modes, the outputs can technically function as Sends
for external audio equipment. However, this isn't their intended purpose and results may
vary.
Back to the function buttons…
Middle Button
● Press once to view information such as sync source and device sample rate.
● Press once while in any menu to exit.
● Hold down to enter Standby mode. Press any function button to exit Standby.
Bottom Button
● Press to mute or un-mute Headphone Output 2 (HP2).