User Manual

Discrete 8 Pro Synergy Core User Manual
Page 53
row works only when the output is set to REAMP mode that can be switched from the
MONITOR 2 section in the main control panel.
COMP REC - This row represents DAW Inputs 1 – 32 (Thunderbolt™) or DAW Inputs 1 –
24 (USB). This is where you send audio to your DAW for recording. To record using a
‘COMP REC’ channel, route audio to it from the ‘Routing’ tab. Create a new track in your
DAW and assign the input with the matching number:
- example 'COMP REC' 1 = DAW 'Input 1'.
ADAT OUT - This row lets you route up to 16 mono audio channels to the ADAT
outputs (2 ports of up to 8 mono audio channels each). Note that ADAT runs on S/MUX.
S/PDIF OUT - This row lets you route 2 audio channels to S/PDIF-compliant equipment
over coaxial RCA cable.
AFX IN - The AFX IN row (‘AFX’ short for 'Antelope FX') lets you route audio into the
Synergy Core FX. You can route up to 16 mono channels and stack up to 8 effects on
each, independent of sample rate. Synergy Core FX are found in the ‘AFX’ tab.
MIX 1-4 IN – The ‘Mixer’ tab is home to four low-latency Direct Monitoring mixers with
32 inputs each. This row lets you route audio to them.
AuraVerb
This is Antelope’s proprietary reverb effect which can be applied as a send on each
channel in MIXER 1. You can use the Auraverb on your Headphones and Monitor mixes by
routing MIXER 1 OUT 1 and 2 to Monitor/HP left and right. If you want to record the
Auraverb in your DAW you would have to route MIXER 1 OUT 1 and 2 into the DAW
section.
AuraVerb provides richness and color using a special new approach and a unique
algorithm. The reverb features eight different controls, including a ‘Color’ parameter to
create everything between darkened textures to bright, sizzling presence. In addition,
there are 24 presets done by award-winning audio engineer and producer Brian Vibberts.