User Manual
Table Of Contents
- CONTENTS
- BEFORE YOU BEGIN
- SETTING UP
- ANTELOPE LAUNCHER
- FRONT PANEL EXPLAINED
- REAR PANEL EXPLAINED
- CONTROL PANEL
- Quick Start
- Mouse & Keyboard Shortcuts
- Main View
- Software Re-amping
- Edge Solo
- Edge Duo
- Edge Duo Mic Emulations Window
- Recording and Monitoring Edge Duo
- Recording and monitoring Edge Duo as a single-membrane condenser mic
- Recording and monitoring Edge Duo as a dual-membrane condenser mic
- Recording and monitoring Edge Duo as a modeling microphone
- Recording and monitoring ‘dry’ and ‘mic emulation’ audio simultaneously
- Edge Quadro
- Verge
- ADVANCED USER TIPS
- CUSTOMER SUPPORT INFORMATION
- MY ANTELOPE AUDIO PRODUCT ISN’T WORKING.
- LIMITED WARRANTY POLICY
- Warranty Coverage
- Limited Factory Refurbished (B-stock) Warranty
- Remedies
- Obsolete or Discontinued Products
- Exclusions
- Limitation of Liability
- Data Recovery
- No Other Warranties
- How to Make a Warranty Claim
- Returning Your Product
- Request a Return Material Authorization Number (RMA#)
- RMA Return Addresses
- Products Lost or Damaged During Transit
- Company information
- SAFETY NOTES
- Blank Page
- Getting Started
- Getting Started
- Gain Calibration
- Gain Calibration
Discrete 8 Pro Synergy Core User Manual
Page 58
MONITORING CONTROL
This section allows you to route different signals directly to the Monitor and Headphone
outputs and adjust their volume.
On the top left corner, you can switch between MONITOR 1, HEADPHONES 1,
HEADPHONES 2 and MONITOR 2.
Each tab has the following:
• 2 Input selectors for the left and right channels – you select the audio source
you want to send to the outputs.
• Volume knob – adjust the volume of the outputs.
• Peak meter – real time visualization of the audio signal going out of the outputs.
• Switch - toggle between MONITOR and REAMP mode (available only in
MONITOR 2 tab). Note that for each mode, there are independent Input selectors.
• Dim button - attenuates the volume of the output with –20dB.
• Mute button - mutes the output.