User Manual
Table Of Contents
- CONTENTS
- BEFORE YOU BEGIN
- SETTING UP
- ANTELOPE LAUNCHER
- FRONT PANEL EXPLAINED
- REAR PANEL EXPLAINED
- CONTROL PANEL
- Quick Start
- Mouse & Keyboard Shortcuts
- Main View
- Software Re-amping
- Edge Solo
- Edge Duo
- Edge Duo Mic Emulations Window
- Recording and Monitoring Edge Duo
- Recording and monitoring Edge Duo as a single-membrane condenser mic
- Recording and monitoring Edge Duo as a dual-membrane condenser mic
- Recording and monitoring Edge Duo as a modeling microphone
- Recording and monitoring ‘dry’ and ‘mic emulation’ audio simultaneously
- Edge Quadro
- Verge
- ADVANCED USER TIPS
- CUSTOMER SUPPORT INFORMATION
- MY ANTELOPE AUDIO PRODUCT ISN’T WORKING.
- LIMITED WARRANTY POLICY
- Warranty Coverage
- Limited Factory Refurbished (B-stock) Warranty
- Remedies
- Obsolete or Discontinued Products
- Exclusions
- Limitation of Liability
- Data Recovery
- No Other Warranties
- How to Make a Warranty Claim
- Returning Your Product
- Request a Return Material Authorization Number (RMA#)
- RMA Return Addresses
- Products Lost or Damaged During Transit
- Company information
- SAFETY NOTES
- Blank Page
- Getting Started
- Getting Started
- Gain Calibration
- Gain Calibration
Discrete 8 Pro Synergy Core User Manual
Page 62
1. Open the Control Panel and head to the leftmost preamp from the PREAMPS row.
Click the middle symbol to the right of the volume indicator until you reach the 'mic'
symbol. Then, click the 'cog wheel' symbol. This will launch the mic emulations window.
Choose Edge Duo with the dial.
2. Adjust microphone gain with the gain knobs. Note that preamps A1 and A2 are now
linked and have identical settings between them.
3. Go to any available mixer, ‘MIXER 1’ in this example, and select ‘EMU MIC 1’ and ‘EMU
MIC 2’ as sources for the first two, or any other mixer channels.
4. Open the ‘HEADPHONES 1’ tab on the bottom of the control panel and make sure the
outputs of the first mixer are selected from the left and right channel dropdown menus,
‘MIXER 1 OUT 1’ and ‘MIXER 1 OUT 2’ respectively.
You should be hearing mic audio in your headphones at this point. Use the
‘HEADPHONES 1’ volume knob or the mix faders for Channels 1 and 2 to adjust output
volume.
Gain Calibration
Gain adjustment for the Edge Solo and Verge is straightforward, but the Edge Duo and
Edge Quadro are multi-membrane microphones. There may be differences in the input
signal strength from each membrane, which is to be expected due to the opposite
directions of the capsules.
Note that engaging mic emulations for Edge Duo and Edge Quadro automatically ‘links’
their input channels, thus individual gain adjustments per input are not possible while
using their mic emulations.
Using Mic Emulations