User Manual

Discrete 8 Pro Synergy Core User Manual
Page 66
membrane. The Left (white) connector is the front membrane, the Right (red) is for the
rear membrane.
The microphone occupies two physical mic preamp inputs and two ‘EMU MIC’ virtual
outputs.
Note: You can use Edge Duo as a single-membrane condenser mic by disconnecting one
of the XLR connectors. In this case, the mic emulations will be visible, but they won’t
function correctly, you cannot swap inputs and you cannot adjust polar pattern.
Recording and monitoring Edge Duo as a single-membrane condenser mic
Route the ‘PREAMP’ input for Edge Duo to your desired outputs to monitor ‘dry’ audio
and record by routing the signal in the DAW tab.
Recording and monitoring Edge Duo as a dual-membrane condenser mic
In this case, you will record and monitor two concurrent mono inputs, one coming from
each membrane. They will sound slightly different in tone and volume, due to the
physical distance between the membranes and the performer. You may have to
compensate with individual gain adjustments for each membrane.
Route the ‘PREAMP’ inputs occupied by Edge Duo to your desired outputs to monitor
‘dry’ audio and record by routing the signal in the DAW tab.
Recording and monitoring Edge Duo as a modeling microphone
Make sure that ‘Edge Duo’ mic emulations are enabled. Route the ‘EMU MIC’ inputs
corresponding to the ‘PREAMP’ inputs occupied by Edge Duo to your desired outputs for
monitoring and record by routing the signals in the DAW tab.
Recording and monitoring ‘dry’ and ‘mic emulation’ audio simultaneously