User Manual
Table Of Contents
- CONTENTS
- BEFORE YOU BEGIN
- SETTING UP
- ANTELOPE LAUNCHER
- FRONT PANEL EXPLAINED
- REAR PANEL EXPLAINED
- CONTROL PANEL
- Quick Start
- Mouse & Keyboard Shortcuts
- Main View
- Software Re-amping
- Edge Solo
- Edge Duo
- Edge Duo Mic Emulations Window
- Recording and Monitoring Edge Duo
- Recording and monitoring Edge Duo as a single-membrane condenser mic
- Recording and monitoring Edge Duo as a dual-membrane condenser mic
- Recording and monitoring Edge Duo as a modeling microphone
- Recording and monitoring ‘dry’ and ‘mic emulation’ audio simultaneously
- Edge Quadro
- Verge
- ADVANCED USER TIPS
- CUSTOMER SUPPORT INFORMATION
- MY ANTELOPE AUDIO PRODUCT ISN’T WORKING.
- LIMITED WARRANTY POLICY
- Warranty Coverage
- Limited Factory Refurbished (B-stock) Warranty
- Remedies
- Obsolete or Discontinued Products
- Exclusions
- Limitation of Liability
- Data Recovery
- No Other Warranties
- How to Make a Warranty Claim
- Returning Your Product
- Request a Return Material Authorization Number (RMA#)
- RMA Return Addresses
- Products Lost or Damaged During Transit
- Company information
- SAFETY NOTES
- Blank Page
- Getting Started
- Getting Started
- Gain Calibration
- Gain Calibration
Discrete 8 Pro Synergy Core User Manual
Page 9
Configuring Windows 10
Windows 10 needs a few tweaks to get everything up and running.
1. Enter the ‘Sounds’ options window from the Control Panel or right-click the speaker
icon in the system tray and choose ‘Open Sound settings’.
2. M
ake sure the Discrete 8 Pro Synergy Core is chosen under 'Output' and 'Input'.
Next, click 'Device Properties' under 'Output'. Then, click 'Additional Device Properties'.
3. Enter the ‘Supported Formats’ tab and place checkmarks next to all the available
sample rates.
4. Enter the ‘Enhancements’ tab and make sure all enhancements are disabled.
5. Enter the ‘Advanced’ tab and choose any of the available “2 channel, 24-bit” modes.
Click ‘OK’ to close the window.
6. Back in Sound settings, click 'Device Properties' under 'Input'. Then, click 'Additional
Device Properties'. Enter the 'Enhancements' tab and disable all enhancements. Click
'OK' to close the window.