Specifications

INSTALLATION AND CONNECTION

1. Before placing the device into its operating location, consider the following:

To minimize frequency instabilities, the device should not be placed near equipment

generating strong magnetic fields, such as generators, transformers, etc.

To prevent possible interference, observe a minimum distance of 5 centimetres (2

inches) between the cables of this device and any non-coaxial audio cables.

It is to use the device unmounted (i.e. not in a rack) as long as the above

conditions are met. There is no requirement for the device to be levelled horizontally

2. If the DC Power Connection is to be used, make sure the power is wired

properly, because reversed polarity may damage the device. Refer to the illustration

below for information on how to make the connection. If in doubt consult a competent

technician.

all right

cable

3. Mount the device on its operating place in the rack and secure it with screws.

4. Connect the AC Power Connection and/or the DC Power Connection to the

respective power outlet(s).

Note: When connecting devices, do so with the studio volume turned down as some devices

may emit an unpleasant sound until properly configured to accept incoming clock.

Connect to the following mark on the

power supply unit circuit board / terminal:

+12 V

Ground

Earth

(optional, use it if available o

n the power

supply unit)

If the

mark on the

Speakon NL4FX plug is…