User Manual

23
With the Zen Studio+ in operating mode, press and hold the standby button to bring up Device
INFO and Factory Reset options in the front panel display. You can scroll between these, using
the Settings buttons. To initiate either of these desired options, press and hold the bottom options
button.
Clock Source ADAT options: (Note that there is no S-Mux check-box for ADAT as it automatically
enabled when you select ADAT 2X or ADAT 4X):
Sample Rate Thunderbolt™ USB A DAT S/PDIF
32 kHz 32 ch 24 ch 16 ch total / 8 ch per line 2 ch
44.1 kHz 32 ch 24 ch 16 ch total / 8 ch per line 2 ch
48 kHz 32 ch 24 ch 16 ch total / 8 ch per line 2 ch
88.2 kHz 32 ch 24 ch 8 ch total / 4 ch per line 2 ch
96 kHz 32 ch 24 ch 8 ch total / 4 ch per line 2 ch
176.4 kHz 32 ch 24 ch 4 ch total / 2 ch per line 2 ch
192 kHz 32 ch 24 ch 4 ch total / 2 ch per line 2 ch
8. Advanced User Tips
Ground Loop Hum and Noise
The design of Zen Studio+ minimizes the possibility of ground loop hum and noise. However, we
recommend the use of shorter, shielded cables and balanced connections for all the audio signals
of your system. All power cables of the system should be connected to a dedicated outlet box
or power conditioner unit to avoid ground current noise affecting the audio signal path. It is also
advisable to keep the layout of your signal and power cables separate.
9. In the box
• Zen Studio+ Portable Audio interface
• Quick Start Guide
• Warranty Card
• 1 USB Cable
• 1 DC Power Adapter