How to Guide

PI-012AP

REVIECER OT

REIFILP

MA OT

POWER INSERTER

5. Install the down lead coax cable (sold separately) to the

“Antenna” input on the back of the digital TV, TV/digital receiver,

or set-top box as shown in Fig. 3.

6. Using the second supplied 3’ coax cable, connect the left port labeled

“To Receiver” on the power inserter (2) to the digital TV,

TV/digital receiver, or set-top box. Do not reverse the connection.

7. Insert the power supply into any 110 volt AC power source, wall

outlet, or power strip.

For New Installation:

TO RECEIVER TO AMPLIFER

Fig.2

PA18 Pre-Amplifier

Antenna

Input

Digital Television

DB2e HDTV Antenna

12v Power Supply

PI-012AP

VIEC

OT R

FILP

Power Inserter

Finished Installation:

The completed installation and assembly of the PA18 Pre-Amplifier should resemble Fig.3.

Important: The power inserter sends power Up the down lead to drive the amplifier mounted on or near the antenna.

The power inserter can be located anywhere in your house, but is usually near the TV. The down lead coax cable

also brings the digital antenna signal into your house and the signal passes though the power inserter to the

Digital TV/Receiver, eliminating any need for a 110VAC wall power source close to the antenna.

Fig.3

Technical Assistance is available Monday - Friday, 9am - 9pm Central Time

and Saturday - Sunday, 10am - 6pm.