Instruction Manual

Installing Your StudioCard Chapter 1 
Antex Electronics Corporation Antex StudioCard  1-7
!
!
Installing
Your
StudioCard
Follow the step-by-step instructions below to install your
StudioCard in your computer.
CAUTION: Static electricity can damage your
StudioCard and your computer. Every time you move,
you are creating static electricity, even though you
can’t see it. Therefore, take the following
precautionary actions while installing your StudioCard:
1. Do not remove the StudioCard from its anti-static
bag until instructed to during the installation
process.
2. Move the StudioCard and its cables in close
proximity to your computer. Once you begin the
installation process, do not walk around with the
StudioCard so that you do not build up static
electricity.
3. Power OFF your computer, then touch the non-
painted backside to discharge static electricity from
your body before touching the circuit board.
CAUTION: The XLR outputs of the StudioCard may be
damaged if connected to microphone inputs that
provide phantom power. The StudioCard outputs are
designed to be connected to equipment that accepts
hi
g
h level sources, not low level micro
p
hone in
p
uts!