Owner`s manual

We at Sonic Frontiers hope you will derive many years
of listening pleasure with your new Anthem Pre 2L. This
Operating Manual contains important information regarding
the operation and care of the Pre 2L. Be sure to read this
manual carefully and follow these instructions in order to
keep it performing and sounding its best. Please contact
Sonic Frontiers if you have any questions, a Customer
Service Representative will be pleased to assist you.
W H AT ’ S I N T H E B O X ?
In addition to the Pre 2L, its covers, and the opera
manual you are presently reading (with associated in
and warranty card), there are a few more items to ta
inventory of before steps are taken to make the Anth
Pre 2L operational.
These items are:
• two matched pairs of 6922 tubes (or equivalen
totaling 4*
• remote handset
• a glove for handling the tubes
• a detachable AC power cord
• 18 screws
• 1 Philips #1 screwdriver
After completing an inventory of these items, procee
the next steps.
*These tubes are carefully measured and matched in
pairs. Take extra care to keep the pairs from being m
and mismatched which would degrade performance.
T E C H N I C A L S P E C I F I C A T I O N S
INPUTS (6) CD, Tuner, Aux 1, Aux 2/Phono, Tape, SSP
OUTPUTS (4) Tape, Power Amplifier, 1/4” Stereo Headphone Jack
CONTROLS (3) Input Select, Balance, Volume
SWITCHES (5) SSP, Tape/EPL (External Processor Loop), Mono/Stereo, Mute/Operate,
Power On/Off
FREQUENCY RESPONSE 2 Hz to 130 kHz
-
0.5 dB; > 250 kHz -3.0 dB at 1VRMS output
THD & N (Output at 1V RMS) < 0.1% from 20 Hz to 20 kHz
GAIN Selectable, 24, 16 & 8dB @ 1kHz
INPUT IMPEDANCE 40k ohms
OUTPUT IMPEDANCE <135 ohms @ 1kHz, all gain settings.
RATED OUTPUT 1 VRMS
MAXIMUM OUTPUT VOLTA G E 30 VRMS at 1% THD
NOISE < 80µV unweighted wideband noise. Approx. 60µV IHF A-weighted noise
-92 dB A-weighted below a 1 VRMS output
STEREO SEPARATION > -60dB @ 1kHz relative to 1VRMS output
(Crosstalk)
TUBE COMPLEMENT 4 - 6922 (6DJ8 types)
FUSE REQUIREMENTS (1) .8 A slow-blo, 5mm x 20mm (100-120VAC countries),
.4A slow-blo (220-240VAC countries)
POWER REQUIREMENTS 60VA Maximum, 100-120VAC 60Hz (Export 220-240VAC 50/60Hz)
DIMENSIONS 19” Wide x 11” Deep x 5.25” High (48 cm x 28 cm x 13 cm)

Summary of content (7 pages)