Owner's Manual

31
AUTO OFF
When there is no input signal the AVM/MRX will turn off after the selected time: 5, 10, or
20 minutes, 1, 2, or 6 hours, or Never.
IP CONTROL
With this setting you can enable/disable response to networked Internet Protocol
commands.
STANDBY IP CONTROL
tWhen disabled, the AVM/MRX goes into a low-consumption standby mode and does
not sense IP commands while in it. To make it respond to a power-on command or to
keep DTS Play-Fi connected to the network so it can be used immediately after power-
on, enable this setting. This can also be used with RS-232 control to avoid sending a
wake-up command.
STANDBY HDMI BYPASS
This option allows use of an HDMI source without turning on the AVM/MRX. Select
HDMI 1-7, Front HDMI, or Last Used. The standby LED on the front panel changes to
red. Your TV may need setup to allow the sound to come from its speakers – check its
manual.
3.8 GENERAL CONFIGURATION
This menu contains power saving, control, and tuner options.
General Configuration
Auto Off 20 minutes
IP Control On
Standby IP Control Off
Standby HDMI Bypass Off
CEC Control Off
CEC Power Off Control Disabled
CEC Power On Control Disabled
FM Tuner Steps 100 kHz