Owner's Manual

Mode
Static IP settings take effect once this setting changes to “Manual.”
Remote Control
This menu offers more advanced control settings.
IP Configuration
TCP Port 14999
Rear IR On
Front IR On
Tx Status IP Only
TCP Port
Change this only if there is a conflict with another application that uses 14999. Available settings are 1025 to 49150.
TCP Port is required for Anthem Room Correction.
Rear and Front IR
This setting allows you to disable each of the MRX/AVM’s infrared inputs, which can be useful when the MRX/AVM is
connected to an IR repeater and is receiving too many signals.
Note that after you disable the front and rear IR inputs, you can no longer control the MRX/AVM with the remote
control. You can re-enable the IR inputs using the front panel buttons. If your remote control is not working and you
have already checked the batteries, check these settings next before contacting technical support.
TX Status
Choose whether all commands, status changes, and control information report through the Ethernet and RS-232
connections or Ethernet only.
Trigger
When connected to the trigger input of another component, such as an amplifier or projector, the MRX/AVM’s trigger
output can turn the connected device on or off according to the trigger’s setup.
MRX 540
Trigger Selection
Trigger Control Menu
Power Main or Zone 2
HDMI 1 Off
HDMI 2 Off
HDMI 3 Off