Owner's Manual
Table Of Contents
Network Setup
How
to
connect your MRX/AVM
to
your network. A network connection is required
for
accessing the Web
UI
, streaming con-
tent, and for running Anthem Room Correction.
Ethernet Connection: The simplest way
to
connect your MRX/AVM
to
your network is by connecting it via Ethernet cable.
This option isn't always available, but it will provide the quickest setup and most secure network connection.
To
connect via
Ethernet, simply take
an
ethernet cable that is connected
to
your network and plug it into the MRX/AVMs Ethernet port on the
rear of the unit.
ETHERNET
□
Wi-Fi Connection (iOS/Android): Download and open the Google Home application.
You
should be prompted that there
is a device available for setup. If not, tap "
x"
followed by "Setup a Device". Select the MRX/AVM and follow the instructions
on screen.
To
listen
to
cast audio from any supported application on your MRX/AVM, ensure your device is connected
to
the
same network as the MRX/AVM. Tap the Chromecast built-in icon from within the application and select the MRX/AVM as the
playback device.
Note: If you connect
to
your network before connecting speakers, you will not hear the connection chime.
Unit Setup
An introduction
to
setting up your MRX/AVM. Full details on the setup can be found
in
the manual on our website:
manuals.anthemav.com/mrx-avm/en
Anthem Web User Interface
The Anthem Web User Interface is a new addition
to
the MRX/AVM line. With your MRX/AVM on the network you can adjust
menu settings with a device connected
to
the same network as the MRX/AVM; a phone, tablet
or
computer will work
as
it
resizes
to
the screen you are using.
To
access the Anthem Web User Interface, you will first need
to
identify your MRX/AVMs
IP
address. This can be found by
entering the MRX/AVM Front Panel Menu: Setup
Menu>
Network/Control> IP Configuration. Once you have your
IP
address you will need
to
use a browser such as Safari or Google Chrome. After opening your browser, enter the
IP
address
into the URL
bar.
Gere-"
Set..,
-·-
Front Panel Menu
-
--
C)
=-
C>
C>
To
access and navigate the Front Panel Menu, you will either need
to
use the Remote or the Front Panel Buttons.
Remote: Press SETUP
to
enter the menu. Once
in
the menu, you can use the UP/DOWN/LEFT/RIGHT and ENTER buttons
to
navigate and make changes.
Front Panel Buttons: Press MENU
to
enter the menu. Once
in
the menu, you can use
PREV
/NEXTNOLUME KNOB and
SELECT
to
navigate and make changes.