Datasheet

0820028F  ESD BENCH MATTING  2 LAYER  SMOOTH FINISH | 12 JANUARY 2023 1:41 PM V1
To request a quotation or for more information, please call +44 (0)1473 836200
email info@antistat.co.uk or visit www.antistat.co.uk
IMPORTANT: This data sheet and its contents (the “Information”) belong to Antistat or are licensed to it. No licence is granted for the use of it other than for information purposes in connection with the products to which it
relates. No licence of any intellectual property rights is granted. The Information is subject to change without notice and replaces all data sheets previously supplied. The Information supplied is believed to be accurate but
Antistat assumes no responsibility for its accuracy or completeness, any error in or omission from it or for any use made of it. Users of this data sheet should check for themselves the Information and the suitability of the
products for their purpose and not make any assumptions based on information included or omitted. Liability for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from
negligence or where Antistat was aware of the possibility of such loss or damage arising) is excluded. © 2023 Antistat.
Grounding
Sucient ground cords should be used to reliably meet EN 61340-5-1 Table 3: less than 1 x 10
9
ohms
for working surfaces. Industry recommendation is that continuous runs of ESD matting should be
grounded at 10ft intervals to allow proper charge decay rates. Each individual ESD mat should be
grounded with ground snaps located no further than five feet from either end.
Cleaning
Please note that contact between the matting surface and any acid or alkali solvent is strictly
prohibited (such as Benzene, Alcohol etc), this will result in the antistatic performance degrading.
If cleaning is required, the matting may be wiped with a cloth coated in a neutral solution (such as
water).
Guidance on use
Matting materials have a tendency to shrink slightly when first unrolled. In applications where length is
critical, allow the material to relax for at least 4 hours before cutting to size. Matting should always be
trimmed with a sharp knife or razor blade.
Cutting tolerances
Width ± 6mm
Length ± 6mm every linear foot of running material
RoHS Compliance
None of the following materials are intentionally added in manufacturing this product: lead, mercury,
cadmium, hexavalent chromium, polybrominated biphenyls (PBB) or polybrominated diphenyl ethers
(PBDE) as outlined in the Directive 2002/95/EC Article 4.1.
Material
Top layer dissipative:
Nitrile - Butadiene rubber
Antistatic agent
Bottom layer conductive:
Perbunan
Super conductive carbon black
Antioxidant
Zinc oxide