Datasheet

ANTISTAT
ESD & PRODUCTION CONSUMABLES
TM
TECHNICAL DATASHEET
ESD Refuse sacks
Our ESD refuse sacks are suitable for holding waste
in an EPA.
Specifically designed for the particular needs of the
electronics industry. The special additives used do not
eect the film clarity or quality, and it is therefore most
economical in use, as the standard film thickness can
be selected.
0910028  ESD REFUSE SACKS | 2 FEBRUARY 2022 1:56 PM V1
 Our ESD refuse sacks are made of
antistatic polyethylene
 Printed in black (printed in white on the
black bags) with ESD caution logo and
text onto polyethylene
 Supplied in packs of 100
 Available in blue, pink, green, yellow,
clear or black from stock
 Homogeneous, non-amine antistatic
polythene film which is effective at low
relative humidities (less than 12%).
PRODUCT
FEATURES
ELECTRICAL PROPERTIES DETAILS
Surafce resistivity (Inside/Outside) at 28.8˚C and 12% RH < 10 Ohms/sq
Static decay rate (5000 volts to 0 volts at 28.8˚C and 12% RH) <2 seconds
To request a quotation or for more information, please call [phone]
email [e-mail] or visit www.antistat.co.uk
IMPORTANT: This data sheet and its contents (the “Information”) belong to Antistat or are licensed to it. No licence is granted for the use of it other than for information purposes in connection with the
products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change without notice and replaces all data sheets previously supplied. The Informa-
tion supplied is believed to be accurate but Antistat assumes no responsibility for its accuracy or completeness, any error in or omission from it or for any use made of it. Users of this data sheet should
check for themselves the Information and the suitability of the products for their purpose and not make any assumptions based on information included or omitted. Liability for loss or damage resulting
from any reliance on the Information or use of it (including liability resulting from negligence or where Antistat was aware of the possibility of such loss or damage arising) is excluded. © 2021 Antistat.
T P D
Thickness 130 Gauge – 32.5 Microns
Tensile Strength (ASTM D 882) 1500 to 3000 psi
Tear Strength (ASTM D 1004) 65 to 450lbs/inch
Elongation (ASTM D 882) MD: 550
Dart Impact (ASTM D 3420) 250-750 grms
Burst (Mullen) (ASTM D 3420) 20 – 60 psi
Heating Sealing (ASTM D 882) Temperature: 250-375˚F
Time .25 – 3.5 seconds
Pressure 30-60 psi