HyTRON ® Nickel Metal Hydride Batter y Owner’s Manual 7595- 0424 Revision A
TABLE OF CONTENTS 1 IMPORTANT INTRODUCTION 2 FEATURES CHARGING 3 BATTERY DISPLAY 4 OPERATING GUIDELINES 5 SERVICE PRECAUTIONS SPECIFICATIONS CHARGE TIMES 6 WARRANTY
IMPORTANT READ AND UNDERSTAND THIS MANUAL BEFORE OPERATION The HyTRON® Logic Series® battery is designed to be charged with current InterActive® chargers. Older model InterActive MP4D, Quad, Lifesaver Dual, ABC800 cannot charge these batteries. Do not attempt to charge on non-InterActive chargers or chargers not manufactured by Anton/Bauer, Inc. Safety circuits in the battery will prevent charging on any charger, which cannot properly address the battery communication.
FEATURES CHARGING 1. Microprocessor Fuel Computer - Accurately monitors the energy in the battery which take into account battery age, self discharge, charge/discharge rate, operating conditions and previously experienced charge/discharge cycles. The battery constantly “learns” its precise state of charge and remaining capacity. This data is automatically transmitted to an InterActive charger.
BATTERY DISPLAY Anton/Bauer Logic Series® batteries feature the RealTime® LCD providing on-the-fly remaining run-time estimates in 15 minute increments as well as simultaneously providing remaining capacity information using the analog “Fuel Gauge” approach. RealTime® automatically calculates the load and displays capacity information and battery status at all times. Additional electronic circuits protect the battery cells from damage and help ensure safe operation.
OPERATING GUIDELINES 1. STORAGE - Keep batteries cool or at room temperatures whenever possible. Sustained elevated temperatures are the primary reason for premature failure of batteries: to the charger. The charge routine will not be initiated by the charger until all other batteries have completed their fast charge routines. Therefore, a low voltage battery can be installed on an InterActive charger without the charger indicating recognition.
SERVICE SPECIFICATIONS In the event a HyTRON battery fails to deliver acceptable performance, it must be returned to Anton/Bauer. No other facility is qualified and equipped to service the HyTRON battery or calibrate the electronic components and sensors.
WARRANTY OTHER PRODUCT OR DEVICE. This warranty for the product specified in this document (“Product”) is given by Anton/Bauer, Inc. (“Anton/Bauer”), 14 Progress Drive, Shelton, Connecticut 06484. If you (the purchaser of the Product from Anton/Bauer, or the person for whom the Product was purchased, if it was a gift) have any questions regarding Product applications, Product specification, or to obtain warranty service on this or any Anton/Bauer product, contact the company at the address above.
The following are trademarks of Anton/Bauer, Inc.
