Customer Sevice Technical Info. Parts & Accessories Promotions www.facebook.
Antra X60 Series Auto-Darkening Welding Helmet User Manual(2017) Read and understand this entire instruction manual before attempting to assemble,install, operate or maintain this tool. Failure to comply with the instructions may result in serious personal injury and/or property damage! ARC RAYS can burn eyes ! Never look at arc welding without proper eye protection.
TECHNICAL SPECIFICATIONS FLYING METAL can injure eyes ! • Welding, chipping, wire brushing, and grinding cause sparks and flying metal. As welds cool, they can throw off slag. • Wear ANSI approved safety glasses with side shields under your welding helmet. AH6-260-XXXX AH7-360-XXXX AH6-660-XXXX AH7-860-XXXX ADF Model AntFi-X60-2 Viewing Area 98 x 42mm / 3.86" x 1.73" AntFi-X60-3 98 x 53mm / 3.86" x 2.09" AntFi-X60-6 98 x 62 mm / 3.86" x 2.44" AntFi-X60-8 98 x 89mm / 3.86" x 3.
7 Adjustable Headband AH7-860-XXXX 6 Lens Retaining Frame • When stored in extremely cold temperature, the helmet should be warmed up to ambient temperature before welding. • Inspect all parts for signs of wear or damage. Any scratched or cracked parts should be replaced prior to use.
ON/OFF The solar unit automatically switches ON when exposed to light. RECOMMENDED SETTINGS 2. SELECT THE SHADE NUMBER Shade 8 Shade 9 Shade 10 Shade 11 Shade 11 Adjustment Knob (Fig.4) Make sure that the adjustment knob is on the "5-9/9-13" position before starting to weld (For AH6-260-XXXX, AH6-660-XXXX)(Fig.4).
Always change both of the batteries when renewing them. LED 4. PRE-WELDING CHECK & BATTERY TESTING AntFi-X60-8 The following procedures should be followed to perform this testing: 1) Make sure there is enough ambient light to trigger the auto darkening lens on. 2) Make sure that "Grind/Weld" switch (Fig.5) is on "Weld" position. 3) Press and hold on the "Batt" button(Fig9) for a second or two: If the LED (Fig9) is ON, and the lens is darken as per shade setting, the helmet is functioning properly.
MAINTENANCE : AH7-860-XXXX REPLACEMENT OF EXTERIOR COVER LENS (Fig.17) (Fig.15) (Fig.16) Pull up the two lock lug on the bottom of the filter (Fig.17), the filter cartridge will pop loose from the shield. Detach the cartridge from the shield and put it aside. Remove the old lens cover. Remove the protect film on the new lens cover(Fig18). Put the new lens cover back onto the shield. REPLACEMENT OF WELDING FILTER 1.
REPLACEMENT OF INNER COVER LENS Detach the auto darkening filter from the helmet shield (Refer to REPLACEMENT OF WELDING FILTER). (Fig.21) (Fig.22) (Fig.23) Lift up one edge of the inner cover lens and pull the cover lens away from the filter(Fig.21). Remove protective film on the new inner lens cover, feed one side of the lens cover (Fig.22) onto lens retaining slots on the filter, then push it slightly all the way until the whole lens cover is snapped on properly.