Specifications

Project No.:ZKT-211130L6532E
Page 33 of 38
6. CHANNEL BANDWIDTH
Test Requirement:
FCC Part15 C Section 15.249/15.215
Test Method:
ANSI C63.10: 2013
6.1 APPLIED PROCEDURES / LIMIT
FCC Part15 (15.249) , Subpart C
Section
Test Item
Frequency Range
(MHz)
Result
15.249(c)
Bandwidth
2400-2483.5
PASS
6.2 TEST PROCEDURE
1. Set resolution bandwidth (RBW) = 1-5% or DTS BW, not to exceed 100 kHz.
2. Set the video bandwidth (VBW) ≥ 3 x RBW.
3. Detector = Peak.
4. Trace mode = max hold.
5. Sweep = auto couple.
6. Allow the trace to stabilize.
7. Measure the maximum width of the emission that is constrained by the frequencies associated with the
two outermost amplitude points (upper and lower) that are attenuated by 6 dB relative to the maximum level
measured in the fundamental emission.
6.3 DEVIATION FROM STANDARD
No deviation.
6.4 TEST SETUP
6.5 EUT OPERATION CONDITIONS
The EUT tested system was configured as the statements of 2.4 Unless otherwise a special operating
condition is specified in the follows during the testing.