MANUFACTURING NUMBERS: 9600200 9600202 9600210 9600212 9600214 9600215 9600217 9600218 CORN COOKER C L IS T ED US AN Models CCC-20 Series 9600200 I T A T IO L IS N S T ED CM P/N 1010634 Rev.
CORN COOKER TABLE OF CONTENTS Equipment Setup .......................................................6 Operating Instructions ...............................................7 Unsold Corn...............................................................7 Operation.....................................................................7 Technical Theory of Operation ..................................8 Cleaning Daily ...........................................................8 Maintenance ..........................
CORN COOKER OWNER INFORMATION (continued) Service/Technical Assistance Refer to the service agency directory included with your unit. If you experience any problems with the installation or operation of your unit, contact your local Roundup Authorized Service Agency. Authorized Service Agency Name: Fill in the information below and have it handy when calling your authorized service agency for assistance. The serial number is on the specification plate located on the unit. Phone No.
CORN COOKER IMPORTANT SAFETY INFORMATION (continued) In addition to the warnings and cautions in this manual, use the following guidelines for safe operation of the unit. • The procedures in this chapter may include the use of chemical products. These chemical products will be highlighted with bold face letters followed by the abbreviated HCS (Hazard Communication Standard). See Hazard Communication Standard manual for the appropriated Material Safety Data Sheets (MSDS).
CORN COOKER SPECIFICATIONS Electrical Ratings Electrical Cord & Plug Configurations Model & Mfg. No. Voltage Watts Amps Hertz Letter Code* Description CCC-20CF 9600200 120 1750 15.0 50/60 C Commercial Cord CCC-20HC 9600202 208, 220-240 2090 10.0, 9.5 - 9.0 50/60 H Harmonized Cord CCC-20CF 9600210 120 1750 15.0 50/60 (H)C** CEE 7/7, 16 Amp., 250 VAC (Assembly Only). CCC-20HC 9600212 208, 202-240 2090 10.0, 9.5 - 9.0 50/60 (C)F*** CCC-20HC 9600214 208, 220-240 2090 10.
CORN COOKER INSTALLATION Unpacking Head Assembly Safety Interlock Switch Beneath Head Assembly 1. Remove unit and all packing materials from shipping carton. 2. Open the large box. Remove all packing materials and protective coverings from the unit and parts. 3. Wash baskets in soap and water. Wipe all surfaces of the unit with a hot damp cloth. NOTE: Do not use a dripping wet cloth. Wring out before use. 4. Install baskets into unit.
CORN COOKER OPERATION Operating Instructions Built in Power Light 1. Fill the Pan about half full of hot tap water. 2. Turn the Rocker Switch (power On/Off) ON. NOTE: If the light on the Rocker Switch does not light up, you must remove and reinstall the Head Assembly onto the pan (Figure 1) to ensure that the Safety Interlock Switch is properly engaged. If the Safety Interlock Switch is not engaged, the Rocker Switch light will not turn on, therefore, the unit will not heat.
CORN COOKER MAINTENANCE 2. Empty the Pan of used water. Wash the Baskets and Pan in hot detergent water. Rinse in clear water and dry. WARNING Turn the unit off, disconnect the power source and allow the unit to cool down before performing any service or maintenance on the unit. 3. Wipe the Head Assembly with a damp cloth, then dry with a clean, dry cloth. CAUTION To prevent damage to the unit, do not use abrasive cleaners on the unit. 4. Install the Head Assembly onto the pan.
CORN COOKER TROUBLESHOOTING WARNING To avoid possible personal injury and/or damage to the unit, inspection, test and repair of electrical equipment should be performed by qualified service personnel. The unit should be unplugged when servicing, except when electrical tests are required. Use extreme care during electrical circuit tests. Live circuits will be exposed. Problem Possible Cause Rocker Switch (power On/Off) is ON, The power cord is not correctly but the unit does not heat and the plugged in.
CORN COOKER REPLACEMENT PARTS Item 1 Part No.
CORN COOKER REPLACEMENT PARTS (continued) Item Part No. Description Quantity Mfg. # 9600200, 202, 210, 212, & 214 36 37 39 NS 310P102* 310P123* 310P146* 0011046 0011769 NS 7000162 7000163 7000164 NS 406P107* Lockwasher, #10 Screw, #10-24 x 1/2” Nut, Hex, KEPS, #10-32 Base Housing Assy. Base Housing Assy. Head Assy. Kit, 120V Head Assy. Kit, 230V Head Assy. Kit, 230V (China) Cable Ties * Only available in packages of 10. P/N 1010634 Rev. I 03/06 1 1 1 1 1 1 1 1 11 Quantity Mfg.
CORN COOKER REPLACEMENT PARTS (continued) INSET 22,24 31 25 29 20 12 10 19 3 18 13 20 23 17 20 30 34 26 14 16 15 11 26 1 28 2 4 3 27 9 8 7 33 5 6 12 P/N 1010634 Rev.
CORN COOKER WIRING DIAGRAM NOTES: ALL WIRES TO BE 12 GA. TEW-105°C UNLESS OTHERWISE SPECIFIED. *18 GA. AWM-105°C #14 GA. AWM-105°C INDICATOR LIGHT GRN GRN-YEL WHT BLK TERMINAL BLOCK # GRN/YEL * BLK G * BLK BLK/BRN WHT/BLU POWER CORD BLK THERMOSTAT BLK GND HEATER INTERLOCK BLK SWITCH 1 2 4 5 WHT POWER SWITCH P/N 1010634 Rev.
CORN COOKER NOTES 14 P/N 1010634 Rev.
CORN COOKER NOTES P/N 1010634 Rev.
LIMITED WARRANTY Equipment manufactured by Roundup Food Equipment Division of A.J. Antunes & Co. has been constructed of the finest materials available and manufactured to high quality standards. These units are warranted to be free from mechanical and electrical defects for a period of one year from date of purchase or 18 months from shipment from factory, whichever occurs first, under normal use and service, and when installed in accordance with manufacturer’s recommendations.
