Manufacturing Numbers: 9100400 9100402 9100410 9100412 C L IS T ED US AN Taco Bell Steamer I T A T IO L IS ERTEK INT N S T ED CM C L IS T ED US Models TBS-1X & TBS-2X P/N 1010698 Rev.
Taco Bell Steamer TBS-2X & TBS-1X Table of contents Owner Information......................................................2 General.......................................................................2 Warranty Information..................................................2 Service/Technical Assistance.....................................3 Important Safety Information.....................................4 Specifications..............................................................6 Electrical Ratings.....
Taco Bell Steamer TBS-2X & TBS-1X Owner information (continued) Service/Technical Assistance Authorized Service Agency If you experience any problems with the installation or operation of your unit, contact your local Roundup Authorized Service Agency. They can be found in the service agency directory packaged with the equipment. Name: Phone No.: Address: Fill in the information below and have it handy when calling your Authorized Service Agency for assistance.
Taco Bell Steamer TBS-2X & TBS-1X Important Safety Information The following warnings and cautions appear throughout this manual and should be carefully observed. In addition to the warnings and cautions in this manual, use the following guidelines for safe operation of the unit. • Turn the power off, unplug the power cord, and allow unit to cool down before performing any service or maintenance. • Read all instructions before using equipment.
Taco Bell Steamer TBS-2X & TBS-1X Important safety information (continued) • Warning electrical shock hazard. Failure to follow these instructions could result in serious injury or death. • To ensure proper steaming characteristics, some mineral deposits must be present on generator surface. If, during cleaning, the surface does become free of mineral deposits, add plain tap water to surface and allow it boil off.
Taco Bell Steamer TBS-2X & TBS-1X Specifications Electrical Ratings Model & Mfg. No. Voltage Watts Amps Hertz TBS-2X 9100400 (per side) 208 3300 15.9 50/60 TBS-2X 9100402 (per side) 220–240 3300 13.8–15 50/60 TBS-1X 9100410 208 3300 15.9 50/60 TBS-1X 9100412 220–240 3300 13.8–15 50/60 Warning All electrical connections must be in accordance with local electrical codes and any other applicable codes. Warning ELECTRICAL SHOCK HAZARD.
Taco Bell Steamer TBS-2X & TBS-1X Installation Unpacking Caution All electrical connections must be in accordance with local electrical codes and any other applicable codes. 1. Remove unit and all packing materials from shipping carton. 2. The box should contain the following: • Taco Bell Steamer • Handle & Handle Guard (Qty. 2 for TBS-2X) • Water Quick Disconnect Kit (Qty.
Taco Bell Steamer TBS-2X & TBS-1X Installation (continued) Plumbing Warning ELECTRICAL SHOCK HAZARD. NOTE: Taco Bell Corporation REQUIRES installation of a Water Demineralizer system for supplying water to this equipment. To purchase the water filtration system, contact the approved equipment distributor. Be sure to read all information and follow all safety procedures in the important safety information section of this manual before performing any of these steps.
Taco Bell Steamer TBS-2X & TBS-1X Installation (continued) Calibration Top Cover A Water Measuring and Calibration Kit is supplied with your unit and consists of the following items: Generator Cover • Two 24” Teflon Tubes • One Measuring Cup Caution This procedure exposes hot surfaces. Use extreme care when performing procedure as to avoid personal injury. Diffuser Figure 3. Steamer Components 1. Turn the power off and allow the unit to cool down before proceeding. Slanted End 2.
Taco Bell Steamer TBS-2X & TBS-1X Operation Operating Instructions NOTE: Steam generator must be calibrated before initial use. See the section titled Calibration in the Installation section of this manual. POWER Power Switch 1. Turn the power on and allow the unit to preheat for approximately 20-30 minutes (Figure 6). TM NOTE: The Green Ready Light (Figure 6) will flash during warm-up. The flashing light will become steady when the unit is up to temperature.
Taco Bell Steamer TBS-2X & TBS-1X Maintenance Warning Turn the power off, unplug the power cord, and allow the unit to cool down before performing any service or maintenance. The TBS-2X has two power cords. Make sure both pwoer cords are unplugged. Chimney Top Cover Caution Chlorides or phosphates in cleaning agents (e.g. bleach, sanitizers, degreasers or detergents) could cause permanent damage to stainless steel equipment.
Taco Bell Steamer TBS-2X & TBS-1X Maintenance (continued) 11. Clean unit surface with a hot, clean, damp cloth (not dripping wet) and wipe dry. Monthly Maintenance Your steamer utilizes an open steam Generator. Water sprayed onto the Generator surface flashes into steam immediately, but the minerals in the water do not steam; they stay on the Generator surface.
Taco Bell Steamer TBS-2X & TBS-1X Maintenance (continued) Slanted end of tube POW ER REA DY STE AM ING CYC STA LE RT CA UT "H ION OT " POW ER CA UT "H ION OT " REA DY STE AM ING CYC STA LE RT Figure 8. Installing Calibration Tubes Figure 9. Water Measurement NOTES: Water may come out of the Calibration Tubes with force. Hold the tubes and cup firmly. CY STCLE AR T 7. Empty all water from the cup, then reinsert the tubes back into the cup. INCR 8 90 3 45 ASE 6 7 SE 9.
Taco Bell Steamer TBS-2X & TBS-1X Troubleshooting Warning To avoid possible personal injury and/or damage to the unit, inspection, test, and repair of electrical equipment should be performed by qualified service personnel. The unit should be unplugged when servicing, except when electrical tests are required. Use extreme care during electrical circuit tests. Live circuits will be exposed.
Taco Bell Steamer TBS-2X & TBS-1X Troubleshooting (continued) Problem Unit only leaks water when powered off. Unit only leaks water when powered on. Possible Cause(s) Corrective Action Solenoid Valve is leaking due to debris trapped within its plunger and seat. Disassemble the Solenoid Valve and clean out the plunger. Reassemble and test. If the a leak is still present, replace the Solenoid Valve. Solenoid Valve is installed incorrectly.
Taco Bell Steamer TBS-2X & TBS-1X Wiring Diagram POWER CORD NOTE: ALL WIRES TO BE 14 GA. TFE-200°C UNLESS OTHERWISE SPECIFIED: (COLOR WIRE)= 14 GA. AWM-105°C {COLOR WIRE}= 18 GA. TFE-200°C WHT BLK GRN = 18 GA. AWM-105°C [COLOR WIRE]= 22 GA.
Taco Bell Steamer TBS-2X & TBS-1X Replacement parts 2 1 48 35 56 59 6 3 5 38 8 4 7 46 51 49 55 9 50 37 47 11 52 30 31 57 26 46 28 58 44 32 46 29 43 16 23 33 17 45 27 18 25 10 12 47 13 19 14 42 53 40 54 39 60 24 61 41 46 21 15 4 20 46 P/N 1010698 Rev.
Taco Bell Steamer TBS-2X & TBS-1X Replacement parts (continued) Item 1 Part No. 5 6 7 8 9 0011229 0011198 7000150 2100250 0503087 0503226 2100247 0503085 0503592 0300129 7000430 10 11 12 4010137 0021110 4060363 13 4060362 14 15 16 17 18 19 4010166 0503315 0020341 2100249 2100107 210K230 20 21 23 24 25 26 27 28 210K123 210K134 4070113 4050135 4040145 2000202 2000203 4030222 2190107 2080117 29 7000139 30 31 405K125 4050180 2 3 4 Description Qty. Item TBS-1X TBS-2X Top Cover Assy.
Taco Bell Steamer TBS-2X & TBS-1X replacement parts (continued) Optional Water Pressure Regulator Kit (P/N 7000314) General: This kit protects your equipment from any foreign debris in the water line that could get into the food, damage the unit’s solenoid (causing the unit to leak or flood) and also prevents excessive and/or fluctuation water pressure from interfering with the equipment’s proper and consistent operation.
LIMITED WARRANTY Equipment manufactured by A.J. Antunes & Co. Foodservice Equipment has been constructed of the finest materials available and manufactured to high quality standards. These units are warranted to be free from mechanical and electrical defects for a period of one year from date of purchase or 18 months from shipment from factory, whichever occurs first, under normal use and service, and when installed in accordance with manufacturer’s recommendations.
