Manufacturing Numbers: 9100210 9100212 9100218 9100220 9100222 9100224 9100230 L IS T ED US Variety Steamer I T A T IO L IS ERTEK INT N S C AN T ED CM C L IS T ED US Models VS-200asb & adb P/N 1010649 Rev.
Variety STeamer Table of contents Table of Contents........................................................2 Owner Information......................................................2 General.......................................................................2 Warranty Information..................................................2 Service/Technical Assistance.....................................3 Model Designation......................................................3 Important Safety Information..........
Variety Steamer Owner information (continued) Service/Technical Assistance Use only genuine Roundup replacement parts in this unit. Use of replacement parts other than those supplied by the manufacturer will void the warranty. Your Authorized Service Agency has been factory trained and has a complete supply of parts for this unit. If you experience any problems with the installation or operation of your unit, contact your Authorized Service Agency.
Variety STeamer Important safety information Throughout this manual, you will find the following safety words and symbols that signify important safety issues with regards to operating or maintaining the Variety Steamer. Warning Warning GENERAL WARNING. Indicates information important to the proper operation of the equipment. Failure to observe may result in damage to the equipment and/or severe bodily injury or death. ELECTRICAL WARNING. Indicates information relating to possible shock hazard.
Variety Steamer Important safety information (continued) • Warning electrical shock hazard. Failure to follow these instructions could result in serious injury or death. • Do NOT clean this appliance with a water jet. • Do NOT use a sanitizing solution or abrasive materials. The use of these may cause damage to the stainless steel finish. - Electrical ground is required on this appliance. - Do NOT modify the power supply cord plug.
Variety STeamer Specifications Electrical Ratings at Listed Supply Voltages Model & Mfg. No. Electrical Cord & Plug Configurations Voltage Watts Amps Hertz VS-200ASB 9100210 208-240 3800 18.3-15.8 50/60 VS-200ASB 9100212 230 3490 15.2 50/60 VS-200ADB 9100218 240 3000 12.5 50/60 VS-200ADB 9100220 208-240 3800 18.3-15.8 50/60 VS-200ADB 9100222 230 3490 15.2 50/60 VS-200ADB 9100224 240 3800 15.8 50/60 VS-200ADB 9100230 208-240 3800 18.3-15.8 50/60 Model & Mfg. No.
Variety Steamer Installation Equipment Setup Unpacking General 1. Remove unit and all packing materials from shipping carton. When placing the unit into service, pay attention to the following guidelines: 2.
Variety STeamer Installation (continued) 5. Release the plastic tip and check the pressure on the Water Pressure Regulator Gauge. It should read 20 psi. Warning Be sure to follow all guidelines, procedures, and precautions listed in the important safety information section of this manual. a.) If it reads less, increase the water pressure by pulling the black knob up and turning it clockwise.
Variety Steamer Operation Operating Instructions 1. Make sure the Lock Lever is in the locked position (Figure 4). Operate Button Green Light 2. Turn the power on and allow the unit to preheat for approximately 20-30 minutes. 1 13 READY 12 11 10 STEAM NOTE: The Ready Light turns on during warmup. Yellow Light NOTE: Do NOT push the OPERATE button during warmup. 4. Press and release the OPERATE button. The Ready Light turns off and the Steam Light turns on during steaming.
Variety STeamer Maintenance Daily Maintenance Warning Turn the power off, unplug the power cord, and allow the unit to cool down before performing any service or maintenance on the unit. NOTE: Frequency of cleaning is determined by water conditions, usage and water filter systems. 1. Turn the power off, unplug the power cord, and allow the unit to cool down.
Variety Steamer Maintenance (continued) Monthly Cleaning 7. Using a sponge or a dry towel, remove the delimer solution from the Generator surface, then rinse with clean water. Your steamer utilizes an open steam generator. Water sprayed onto the Generator surface flashes into steam immediately, but the minerals in the water do not steam; they stay on the Generator surface and accumulate.
Variety STeamer Maintenance (continued) Checking and Cleaning the Water Strainer The Water Strainer protects your equipment by preventing foreign debris from reaching the water line, which could get into the food, damage the unit’s solenoid (causing the unit to leak or flood), or interfere with the equipment’s proper and consistent operation. To ensure proper and consistent steaming results, inspect the Water Pressure Regulator and strainer cup regularly. If the pressure is lower than 20 psi (1.
Variety Steamer Maintenance (continued) Black Manifold Plate (2) Black Manifold Orifices O-ring (3) Top Cover Assy. (1) Drip Tray (4) Diffuser (38) Spray Tube (37) Hi-Limit Thermostat (35) Control Panel Screws (59) Steam Generator Control Panel (32) Control Panel Screws (59) NOTE: Numbers in parenthesis correspond with Replacement Parts list. Figure 5. Variety Steamer Components P/N 1010649 Rev. G 03/12 13 A.J. Antunes & Co.
Variety STeamer Troubleshooting Warning To avoid possible personal injury and/or damage to the unit, qualified service personnel should inspect, test, and repair all electrical equipment. The unit should be unplugged when servicing, except when electrical tests are required. Use extreme care during electrical circuit tests. Live circuits will be exposed. Problem The unit is on, but the Switch Indicator Light is still off and the unit is not heating up.
Variety Steamer Troubleshooting (continued) Problem Possible Cause Unit heats but there is little Insufficient or excessive calcium/mineral or no steam produced buildup on Generator Surface. and/or Corrective Action Verify that a thin layer of calcium/mineral deposits is present on the Generator Surface. Refer to the Maintenance section of this manual. The product requires more Black Manifold O-ring is worn, damaged, or missing. steaming than usual. Low Generator temperature.
Variety STeamer Replacement Parts Water Pressure Regulator Kit - Part No. 7000314 1 4 3 6 Item 1 2 2 3 4 5 6 7 5 Part No. 0503849 2040130 See Below 2170113 7000306 2190129 211P104 Description Bracket Qty. Male Adapter, Barbed 1/4” For Strainer Parts Identification Regulator, Pressure Gauge, Water Pressure Nipple, 1/4” NPT x 1/4” NPT Clamp, Worm (not shown) 1 2 1 1 1 2 1/4 Item NPT 2 NOTE: Item 1 is made up of Items 2–4. 1 2 3 4 2 7000333 2040130 7000334 2110104 Description Qty.
Variety Steamer Replacement parts (continued) 43 2 17 67 3 18 38 44 37 39 63 40 5 4 40 1 42 63 74 36 6 12 68 9 69 70 34 8 13 11 71 66 60 64 C 65 51 35 59 73 72 8 10 21 16 15 19 53 14 7 55 58 54 22 33 49 32 57 58 20 31 56 23 30 29 28 27 P/N 1010649 Rev. G 03/12 57 24 25 26 17 A.J. Antunes & Co.
Variety STeamer Replacement parts (continued) Item 1 2 3 4 5 Part No. 0021042 0100180 0200121 0010336 7000388 0100259 6 2020104 7 040K103 8 0501139 9 001K125 10 2100138 11 0021044 12 7000449 13 200K126 14 0020419 15 200K127 16 208K106 17 7000139 18 0010584 19 0700452 0700453 0700437 0700556 20 210K230 21 0020443 22 4050170 23 4020131 24 1000955 25 210K122 26 210K108 27 7000542 28 2100123 29 4010166 30 4060208 31 4060179 32 0021043 33 402K169 Description Qty. Item Top Housing Assy.
Variety Steamer Wiring Diagram P/N 1010649 Rev. G 03/12 19 A.J. Antunes & Co.
Limited Warranty Equipment manufactured by Roundup Food Equipment Division of A.J. Antunes & Co. has been constructed of the finest materials available and manufactured to high quality standards. These units are warranted to be free from electrical and mechanical defects for a period of one (1) year from date of purchase under normal use and service, and when installed in accordance with manufacturer’s recommendations.